EVAP Emissions Control Fault Codes (Auto & OBD-II)
54 diagnostic trouble codes covering EVAP Emissions Control (Automotive & OBD-II) with symptom triage and fix steps.
Our EVAP Emissions Control index covers 54 fault codes in Automotive & OBD-II, led by high-frequency lookups like P0442, P0455, P0440, P0456. Of these, 5 carry high or critical urgency ratings requiring prompt inspection.
- Auto & OBD-II
- 54 codes indexed
- Urgency
- 5 high / critical
- Popular Fault Codes
- P0442
Evaporative Emission (EVAP) System Small Leak Detected (0.040" / 1 mm)
Fuel vapor containment failed a ~0.040 in (1 mm) / 0.020 in pressure-decay leak test—most commonly caused by a loose or cracked rubber gas cap gasket, split EVAP purge hose, or leaking canister vent seal.
Evaporative Emission (EVAP) System Large Leak Detected
Zero tank vacuum built up during the EVAP pull-down test—such as failing to reach ~-2 kPa in 30 s (Ford) or 2,740 Pa after 20 L purge (GM)—usually caused by a missing/loose gas cap, popped EVAP hose, stuck-open vent valve, or stuck-closed purge solenoid.
OBD-II P0440: Evaporative Emission (EVAP) Control System Malfunction
General EVAP self-test fail across purge, vent, or tank sealing—check **gas cap O-ring** first, then ohm-test **purge (`18–30 Ω`) & vent (`20–40 Ω`) solenoids**, verify **FTP sensor baseline (`~2.5–3.0 V` KOEO cap off)**, and pinpoint leaks with a **low-pressure EVAP smoke test**.
OBD-II P0456: EVAP System Very Small Leak Detected (0.020 in)
CARB/EPA **`0.020-inch (0.5 mm)` micro-leak** threshold tripped (half the `0.040 in` P0442 pinhole)—inspect the **gas cap gasket & rusted filler neck lip**, check **purge valve weep**, and pinpoint with a **low-pressure EVAP smoke tester (`~0.5–1.0 psi`)**.
OBD-II P0446: EVAP Emission Control System Vent Control Circuit
SAE J2012 emissions fault when the **canister vent solenoid** sticks closed/open, its **20–40 Ω** (up to **50–70 Ω**) coil circuit faults, or the charcoal canister fresh-air filter plugs—often causing **slow gas-pump click-offs** during refueling.
OBD-II P0496: EVAP System High Purge Flow (Flow During Non-Purge)
SAE J2012 EVAP fault when the **canister purge solenoid sticks physically open**, drawing **continuous intake vacuum into the fuel tank even when commanded `0%` closed**—famous for causing **hard starts right after filling the gas tank**; verify via idle hose suction test and coil check (`18–30 Ω`).
OBD-II P0441: Evaporative Emission (EVAP) System Incorrect Purge Flow
SAE J2012 EVAP code triggered when the PCM sees **purge flow while commanded closed OR zero vacuum/pressure drop when commanded open**—inspect **split purge vacuum lines**, test **purge solenoid (`18–30 Ω`) & idle suction**, check **canister vent valve (`20–40 Ω`)**, and verify **FTP atmospheric voltage (`~2.5–3.0 V` cap off)**.
OBD-II P0449: EVAP System Vent Valve / Solenoid Control Circuit
Pure electrical open or short circuit in the rear charcoal canister vent valve solenoid—frequently triggered by road-salt pigtail corrosion; check the EVAP fuse, verify `20–40 Ω` solenoid coil resistance, and test `12 V` ignition feed plus ECM ground control.
OBD-II P0451: EVAP System Pressure Sensor / Switch Range / Performance
Fuel Tank Pressure (`FTP`) sensor reads erratically, drifts, or stays stuck off atmospheric baseline—verify KOEO open-cap baseline (`~2.5–3.0 V` by OEM), `5.0 V` reference/ground, plugged canister vent, or corroded top-of-tank FTP plug.
EVAP System Purge Control Valve A Circuit
OBD-II P0443: EVAP System Purge Control Valve A Circuit
EVAP System Purge Control Valve A Circuit Open
OBD-II P0444: EVAP System Purge Control Valve A Circuit Open
EVAP System Purge Control Valve A Circuit Shorted
OBD-II P0445: EVAP System Purge Control Valve A Circuit Shorted
EVAP System Vent Control Circuit Open
OBD-II P0447: EVAP System Vent Control Circuit Open
EVAP System Vent Control Circuit Shorted
OBD-II P0448: EVAP System Vent Control Circuit Shorted
EGR Sensor C Circuit
OBD-II P044A: EGR Sensor C Circuit
EGR Sensor C Circuit Range/Performance
OBD-II P044B: EGR Sensor C Circuit Range/Performance
EGR Sensor C Circuit Low
OBD-II P044C: EGR Sensor C Circuit Low
EGR Sensor C Circuit High
OBD-II P044D: EGR Sensor C Circuit High
EGR Sensor C Circuit Intermittent/Erratic
OBD-II P044E: EGR Sensor C Circuit Intermittent/Erratic
AIR System Switching Valve A Circuit High
OBD-II P044F: AIR System Switching Valve A Circuit High
EVAP System Pressure Sensor/Switch A Circuit
OBD-II P0450: EVAP System Pressure Sensor/Switch A Circuit
EVAP System Pressure Sensor/Switch A Circuit Low
OBD-II P0452: EVAP System Pressure Sensor/Switch A Circuit Low
EVAP System Pressure Sensor/Switch A Circuit High
OBD-II P0453: EVAP System Pressure Sensor/Switch A Circuit High
EVAP System Pressure Sensor/Switch A Circuit Intermittent
OBD-II P0454: EVAP System Pressure Sensor/Switch A Circuit Intermittent
EVAP System Leak Detected (fuel cap loose/off)
OBD-II P0457: EVAP System Leak Detected (fuel cap loose/off)
EVAP System Purge Control Valve A Circuit Low
OBD-II P0458: EVAP System Purge Control Valve A Circuit Low
EVAP System Purge Control Valve A Circuit High
OBD-II P0459: EVAP System Purge Control Valve A Circuit High
EGR B Control Circuit
OBD-II P045A: EGR B Control Circuit
EGR B Control Circuit Range/Performance
OBD-II P045B: EGR B Control Circuit Range/Performance
EGR B Control Circuit Low
OBD-II P045C: EGR B Control Circuit Low
EGR B Control Circuit High
OBD-II P045D: EGR B Control Circuit High
EGR B Control Stuck Open
OBD-II P045E: EGR B Control Stuck Open
EGR B Control Stuck Closed
OBD-II P045F: EGR B Control Stuck Closed
EGR A Control Circuit High
OBD-II P0490: EGR A Control Circuit High
AIR System Insufficient Flow Bank 1
OBD-II P0491: AIR System Insufficient Flow Bank 1
AIR System Insufficient Flow Bank 2
OBD-II P0492: AIR System Insufficient Flow Bank 2
Fan Overspeed
OBD-II P0493: Fan Overspeed
Fan 1 Underspeed
OBD-II P0494: Fan 1 Underspeed
Fan 1 Overspeed
OBD-II P0495: Fan 1 Overspeed
EVAP System Low Purge Flow
OBD-II P0497: EVAP System Low Purge Flow
EVAP System Vent Valve Control Circuit Low
OBD-II P0498: EVAP System Vent Valve Control Circuit Low
EVAP System Vent Valve Control Circuit High
OBD-II P0499: EVAP System Vent Valve Control Circuit High
EGR B Flow
OBD-II P049A: EGR B Flow
EGR B Flow Insufficient Detected
OBD-II P049B: EGR B Flow Insufficient Detected
EGR B Flow Excessive Detected
OBD-II P049C: EGR B Flow Excessive Detected
EGR A Control Position Exceeded Learning Limit
OBD-II P049D: EGR A Control Position Exceeded Learning Limit
EGR B Control Position Exceeded Learning Limit
OBD-II P049E: EGR B Control Position Exceeded Learning Limit
Exhaust Pressure Control Valve B
OBD-II P049F: Exhaust Pressure Control Valve B
Frequently Asked Questions
What causes EVAP Emissions Control fault codes?
Codes under EVAP Emissions Control (Automotive & OBD-II) indicate out-of-range sensor signals, circuit faults, mechanical wear, or leaks within that subsystem. Notable examples include P0442, P0455, P0440, P0456.
Are EVAP Emissions Control fault codes safe to ignore?
5 of the 54 indexed EVAP Emissions Control codes are flagged high or critical urgency. Even low-severity alerts can trigger failed inspections or secondary damage if left unresolved.
How much does it cost to repair a EVAP Emissions Control fault?
Repair costs range from $0–$50 for DIY connector, fuse, or hose fixes to professional service rates depending on the affected module. Open any specific code page below to compare DIY parts vs. professional labor estimates.