FaultCodes.org
P0490OBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P0490 Fault Code: EGR A Control Circuit High

OBD-II P0490 (EVAP Emissions Control): EGR A Control Circuit High.

Quick AnswerLow — Minor Issue

OBD-II fault code P0490 indicates EGR A Control Circuit High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$756.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
EVAP Emissions Control
Professional Repair
$54 – $756

What This Fault Code Means

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. P0490 means the drive circuit of EGR valve A is shorted to battery voltage, or its output stage sees overcurrent. GM's Duramax LML sets it at 0.5 Ω or less to the supply for 3 s, GM's 2017 diesels at an H-bridge current above 8 A (160 of 200 samples), Ford diesels after 0.35 s – MIL after two trips. The output stage switches off for protection and the valve falls into its spring position, closed; EGR is off.

Common Symptoms

  • Check engine light on
  • EGR switched off, usually no noticeable change
  • Higher NOx

Most Likely Root Causes

  • Harness shorted to a supply wire (chafing)
  • EGR valve with shorted turns (low resistance, overcurrent)
  • Moisture in the connector
  • Driver in the engine module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0490.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Egr Valve.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0490?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Egr Valve.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Egr Valve.
  5. 5Clear fault memory and run a verification cycle to confirm P0490 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $318
Professional Repair (Parts + Labor)$54 – $756

Frequently Asked Questions

Is it safe to keep operating with fault code P0490?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0490?

DIY replacement parts average $19–$318, while professional service averages $54–$756.

Will resetting P0490 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0490 fault code meaningP0490 repair costhow to fix P0490

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P0490 Fault Code: EGR A Control Circuit High — Causes, Fixes & Cost | FaultCodes.org