FaultCodes.org
P0455OBD-IIEVAP Emissions ControlVerified Guide· Updated: Nov 22, 2026

P0455 Fault Code: Evaporative Emission (EVAP) System Large Leak Detected

Zero tank vacuum built up during the EVAP pull-down test—such as failing to reach ~-2 kPa in 30 s (Ford) or 2,740 Pa after 20 L purge (GM)—usually caused by a missing/loose gas cap, popped EVAP hose, stuck-open vent valve, or stuck-closed purge solenoid.

Quick AnswerLow — Minor Issue

Code P0455 means the EVAP system detected a gross/large vapor leak (or failed purge flow unable to pull any vacuum): Ford triggers P0455 when closed-system purge fails to draw ~-2 kPa within 30 seconds (P0457 appears right after refueling), GM trips when 20 L of vapor purges without hitting 2,740 Pa tank vacuum across two cold-start trips, and Saab ME9 checks drops below 525 Pa. Your car remains safe to drive normally. Start by checking the fuel cap (even cross-threaded/missing) and snapped EVAP plastic lines under the hood/tank before testing the purge & vent valves ($0–$95 DIY; $135–$340 shop).

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Easy (Basic Tools)
System
EVAP Emissions Control
Professional Repair
$135 – $340

What This Fault Code Means

To confirm there is no major breach venting raw gasoline vapors, the ECM seals the canister vent solenoid and opens the engine-bay purge valve slightly to pull vacuum across the tank. If a cap was left on the pump roof, a plastic line unclipped during recent service, the rear vent solenoid jammed open, OR the front purge solenoid jammed shut (no vacuum passes into the tank!), P0455 stores immediately.

Common Symptoms

  • Solid Check Engine Light (frequently right after filling up if cap wasn't clicked tight)
  • Noticeable gasoline odor around the vehicle or fuel filler neck on warm days
  • Zero drivability loss in most cases—occasional stumbling if a detached EVAP purge hose creates a vacuum leak

Most Likely Root Causes

  • Missing, unseated, loose, or cross-threaded fuel filler cap (#1 cause)
  • Disconnected or broken plastic EVAP hose under the hood (near purge valve) or by the rear fuel tank/canister
  • Canister Vent Solenoid Valve jammed mechanically open (dirt/rust) OR EVAP Purge Solenoid Valve jammed closed (blocking vacuum pull)
  • Rusted-through steel fuel filler neck pipe, cracked charcoal canister, or bad Fuel Tank Pressure (FTP) sensor

Technical Thresholds & Specifications

Parameter / ConditionFactory Spec / Threshold
Ford Pull-Down Vacuum Criterion

Post-refuel cap failures log P0457 instead (Motorcraft OBD Summary)

Must reach ~-2 kPa within 30 s
GM Large-Leak / Purge Criterion

Runs once per cold start; MIL illuminates after 2 consecutive trips

< 2,740 Pa vacuum after 20 L purged
Saab ME9 Vacuum Drop Threshold

Also covers blocked purging (stuck-closed purge solenoid)

Pressure drop < 525 Pa

Commonly Affected Models & Service Bulletins

  • Ford Vehicles (Motorcraft Gasoline OBD Summary -2 kPa / 30 s pull-down spec)
  • GM Cars, Trucks & SUVs (Mode 6 18OBDG03A 2,740 Pa / 20 L test & NHTSA TSB MC-10216318)
  • Vehicles after air-box/spark-plug maintenance with bumped EVAP hose quick-connects or forgotten gas caps

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Verify the fuel cap sits tight (or clean a sticking capless Easy Fuel funnel flap) and listen around the rear filler pipe/canister for fuel smell.
  2. 2Inspect engine-bay EVAP quick-connect lines around the intake manifold and purge solenoid (especially if the car had recent battery, air-filter, or spark-plug work where hoses get bumped loose).
  3. 3Remove the EVAP purge solenoid and test with 12V: a stuck-CLOSED purge valve produces the exact same zero-vacuum P0455 failure as a giant hole! Verify the rear vent solenoid closes tight when 12V-energized.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Was the gas cap left loose/missing, OR was under-hood maintenance just completed before P0455 appeared?

Step-by-Step Troubleshooting & Fix

Tools & Parts Reference

OBD-II scanner (view Fuel Tank Pressure & EVAP monitor status)12V test leads / multimeter (bench-testing purge & vent valves)Low-pressure (~1 psi) automotive EVAP smoke machineOEM replacement gas cap or EVAP quick-connect hose clips
  1. 1Seat or replace a missing/loose OEM fuel filler cap (or clean capless filler gaskets with a plastic funnel per manufacturer owner manuals).
  2. 2Snap any popped-off quick-connect EVAP lines securely back onto the purge valve, firewall hardlines, and charcoal canister.
  3. 3Bench-test the EVAP purge valve (must seal unpowered and flow freely when given 12V) and rear vent valve (must close completely when powered); replace whichever solenoid hangs.
  4. 4If valves and hoses check tight, perform a ~1 psi EVAP smoke test to catch rusted steel filler necks or cracked fuel-pump top seals, then clear P0455.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$0 – $95
Professional Repair (Parts + Labor)$135 – $340

Recommended Diagnostic Tools & Replacement Parts

Check OEM specifications and compatible tools for this repair.

Frequently Asked Questions

Can a stuck-closed purge valve cause P0455 even with zero physical leaks?

Yes! Official Ford, GM, and Saab EVAP specs note that P0455 triggers whenever vacuum fails to reach threshold—either because air enters through a huge leak OR because a stuck-closed purge solenoid blocks manifold vacuum from ever reaching the tank.

Is P0455 safe to drive?

Yes—P0455 affects fuel-vapor emissions rather than core engine lubrication or braking, unless a loose engine-bay vacuum hose is causing rough idling.

Related Searches & Questions

p0455p0455 codep0455 code chevyp0455 engine codep0455 fordp0455 toyotap0455 hyundaip0455 chevyp0455 nissanp0455 dodgep0455 meaningp0455 code meaning

Verified Official & Engineering References

Plain Text / AI View

Related Fault Codes

Auto & OBD-II →
P0455 Fault Code: Evaporative Emission (EVAP)… — Fixes & Cost | FaultCodes.org