# OBD-II P0455: Evaporative Emission (EVAP) System Large Leak Detected

> **Quick Answer:** Code P0455 means the EVAP system detected a **gross/large vapor leak** (or failed purge flow unable to pull any vacuum): Ford triggers P0455 when closed-system purge fails to draw `~-2 kPa` within 30 seconds (`P0457` appears right after refueling), GM trips when `20 L` of vapor purges without hitting `2,740 Pa` tank vacuum across two cold-start trips, and Saab ME9 checks drops below `525 Pa`. Your car remains safe to drive normally. Start by checking the **fuel cap** (even cross-threaded/missing) and snapped EVAP plastic lines under the hood/tank before testing the **purge & vent valves** ($0–$95 DIY; $135–$340 shop).

- **URL:** https://faultcodes.org/automotive/obd2-p0455
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T00:00:00Z

## What This Fault Code Means
To confirm there is no major breach venting raw gasoline vapors, the ECM seals the canister vent solenoid and opens the engine-bay purge valve slightly to pull vacuum across the tank. If a cap was left on the pump roof, a plastic line unclipped during recent service, the rear vent solenoid jammed open, OR the front purge solenoid jammed shut (no vacuum passes into the tank!), P0455 stores immediately.

## Technical Thresholds & Specifications
| Parameter / Condition | Factory Spec / Threshold | Note |
| --- | --- | --- |
| Ford Pull-Down Vacuum Criterion | Must reach ~-2 kPa within 30 s | Post-refuel cap failures log P0457 instead (Motorcraft OBD Summary) |
| GM Large-Leak / Purge Criterion | < 2,740 Pa vacuum after 20 L purged | Runs once per cold start; MIL illuminates after 2 consecutive trips |
| Saab ME9 Vacuum Drop Threshold | Pressure drop < 525 Pa | Also covers blocked purging (stuck-closed purge solenoid) |

## Commonly Affected Models & Service Bulletins
- Ford Vehicles (Motorcraft Gasoline OBD Summary -2 kPa / 30 s pull-down spec)
- GM Cars, Trucks & SUVs (Mode 6 18OBDG03A 2,740 Pa / 20 L test & NHTSA TSB MC-10216318)
- Vehicles after air-box/spark-plug maintenance with bumped EVAP hose quick-connects or forgotten gas caps

## Common Symptoms
- Solid Check Engine Light (frequently right after filling up if cap wasn't clicked tight)
- Noticeable gasoline odor around the vehicle or fuel filler neck on warm days
- Zero drivability loss in most cases—occasional stumbling if a detached EVAP purge hose creates a vacuum leak

## Most Likely Root Causes
- Missing, unseated, loose, or cross-threaded **fuel filler cap** (#1 cause)
- Disconnected or broken plastic EVAP hose under the hood (near purge valve) or by the rear fuel tank/canister
- **Canister Vent Solenoid Valve** jammed mechanically open (dirt/rust) OR **EVAP Purge Solenoid Valve** jammed closed (blocking vacuum pull)
- Rusted-through steel fuel filler neck pipe, cracked charcoal canister, or bad Fuel Tank Pressure (FTP) sensor

## Tools & Parts Reference
- OBD-II scanner (view Fuel Tank Pressure & EVAP monitor status)
- 12V test leads / multimeter (bench-testing purge & vent valves)
- Low-pressure (~1 psi) automotive EVAP smoke machine
- OEM replacement gas cap or EVAP quick-connect hose clips

## Step-by-Step Troubleshooting & Fix
1. Seat or replace a missing/loose OEM fuel filler cap (or clean capless filler gaskets with a plastic funnel per manufacturer owner manuals).
2. Snap any popped-off quick-connect EVAP lines securely back onto the purge valve, firewall hardlines, and charcoal canister.
3. Bench-test the **EVAP purge valve** (must seal unpowered and flow freely when given 12V) and rear **vent valve** (must close completely when powered); replace whichever solenoid hangs.
4. If valves and hoses check tight, perform a ~1 psi EVAP smoke test to catch rusted steel filler necks or cracked fuel-pump top seals, then clear P0455.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $0–$95 | $135–$340 |
| GBP | £0–£75 | £105–£265 |
| CAD | CA$0–CA$125 | CA$175–CA$445 |
| EUR | €0–€85 | €120–€310 |
| CHF | CHF 0–CHF 105 | CHF 160–CHF 385 |

## Frequently Asked Questions
### Can a stuck-closed purge valve cause P0455 even with zero physical leaks?
Yes! Official Ford, GM, and Saab EVAP specs note that P0455 triggers whenever vacuum fails to reach threshold—either because air enters through a huge leak OR because a stuck-closed purge solenoid blocks manifold vacuum from ever reaching the tank.

### Is P0455 safe to drive?
Yes—P0455 affects fuel-vapor emissions rather than core engine lubrication or braking, unless a loose engine-bay vacuum hose is causing rough idling.


## Verified Official & Engineering References
- [Ford Motorcraft Gasoline OBD Operations Summary](https://www.fordservicecontent.com/Ford_Content/catalog/motorcraft/OBD-Operations-Summary-Gasoline-2020-2023.pdf) (Technical Manual)
- [GM Engine OBD Diagnostics Mode 6 (18OBDG03A)](https://gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A%20Engine%20Diagnostics.pdf) (Technical Manual)
- [NHTSA Service Bulletin MC-10216318 (EVAP Gross Leak P0455)](https://static.nhtsa.gov/odi/tsbs/2017/MC-10216318-9999.pdf) (Service Bulletin (TSB))
