Overheat Protection & Circulation Fault Codes (HVAC & Boilers)
3 diagnostic trouble codes covering Overheat Protection & Circulation (HVAC, Boilers & Heating) with symptom triage and fix steps.
Our Overheat Protection & Circulation index covers 3 fault codes in HVAC, Boilers & Heating, led by high-frequency lookups like E9, F2, F.20. Of these, 3 carry high or critical urgency ratings requiring prompt inspection.
- HVAC & Boilers
- 3 codes indexed
- Urgency
- 3 high / critical
- Popular Fault Codes
- E9
Worcester Bosch E9 Fault Code: Central Heating Overheat Safety Limiter (105 °C)
High-limit lockout triggered when the central heating flow Safety Temperature Limiter exceeds `105 °C` (often logged with sub-codes `219`, `220`, `221`, or `224`)—check cold pressure (`1.0–1.5 bar`) and open valves, then book a Gas Safe engineer.
Viessmann Boiler Fault F2: Overheat Safety Temperature Limiter (STB) Tripped
Burner safety lockout triggered when primary heat-exchanger flow hits `~90–100 °C` and trips the hardwired **Safety Temperature Limiter (STB)**—check `1.0–1.5 bar` pressure, radiator flow, or frozen condensate drain; do NOT force repeated resets.
Vaillant Boiler Fault F.20: Safety Switch-Off via Temperature Limiter (STB)
Hardwired Safety Temperature Limiter (**STB**) tripped independently near `~97 °C` to stop burner overheat—check cold pressure (`1.0–1.5 bar`) and open valves, perform one cool reset, and call a certified engineer if `F.20` repeats.
Frequently Asked Questions
What causes Overheat Protection & Circulation fault codes?
Codes under Overheat Protection & Circulation (HVAC, Boilers & Heating) indicate out-of-range sensor signals, circuit faults, mechanical wear, or leaks within that subsystem. Notable examples include E9, F2, F.20.
Are Overheat Protection & Circulation fault codes safe to ignore?
3 of the 3 indexed Overheat Protection & Circulation codes are flagged high or critical urgency. Even low-severity alerts can trigger failed inspections or secondary damage if left unresolved.
How much does it cost to repair a Overheat Protection & Circulation fault?
Repair costs range from $0–$50 for DIY connector, fuse, or hose fixes to professional service rates depending on the affected module. Open any specific code page below to compare DIY parts vs. professional labor estimates.