FaultCodes.org
P0448OBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P0448 Fault Code: EVAP System Vent Control Circuit Shorted

OBD-II P0448 (EVAP Emissions Control): EVAP System Vent Control Circuit Shorted.

Quick AnswerLow — Minor Issue

OBD-II fault code P0448 indicates EVAP System Vent Control Circuit Shorted. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$756.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
EVAP Emissions Control
Professional Repair
$54 – $756

What This Fault Code Means

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0448 is the short-circuit code of the older scheme for the vent valve. Subaru (also in the Saab 9-2X) expects supply voltage above 10 V at the module output with the valve off; a short to positive or a coil below 1 Ω sets the code after two drives, and Subaru then also replaces the module, as its driver may be damaged. Nissan and Infiniti use P0448 differently, for a vent valve or vent path stuck closed by dust or water, with replacement of canister, valve and filler tube. GM and Ford do not use the code.

Common Symptoms

  • Check engine light on
  • Refuelling problems if the vent is blocked
  • EVAP leak test does not run

Most Likely Root Causes

  • Vent valve or vent path blocked by dust, dirt or water (Nissan reading)
  • Vent valve coil shorted (below 1 Ω)
  • Control wire shorted to positive
  • Module driver damaged

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0448.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Evap Vent Valve.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0448?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Evap Vent Valve.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Evap Vent Valve.
  5. 5Clear fault memory and run a verification cycle to confirm P0448 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $318
Professional Repair (Parts + Labor)$54 – $756

Frequently Asked Questions

Is it safe to keep operating with fault code P0448?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0448?

DIY replacement parts average $19–$318, while professional service averages $54–$756.

Will resetting P0448 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0448 fault code meaningP0448 repair costhow to fix P0448

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P0448 Fault Code: EVAP System Vent Control Circuit Shorted | FaultCodes.org