# OBD-II P0448: EVAP System Vent Control Circuit Shorted

> **Quick Answer:** OBD-II fault code P0448 indicates EVAP System Vent Control Circuit Shorted. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$756.

- **URL:** https://faultcodes.org/automotive/obd2-p0448
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0448 is the short-circuit code of the older scheme for the vent valve. Subaru (also in the Saab 9-2X) expects supply voltage above 10 V at the module output with the valve off; a short to positive or a coil below 1 Ω sets the code after two drives, and Subaru then also replaces the module, as its driver may be damaged. Nissan and Infiniti use P0448 differently, for a vent valve or vent path stuck closed by dust or water, with replacement of canister, valve and filler tube. GM and Ford do not use the code.

## Common Symptoms
- Check engine light on
- Refuelling problems if the vent is blocked
- EVAP leak test does not run

## Most Likely Root Causes
- Vent valve or vent path blocked by dust, dirt or water (Nissan reading)
- Vent valve coil shorted (below 1 Ω)
- Control wire shorted to positive
- Module driver damaged

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Vent Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Vent Valve.
5. Clear fault memory and run a verification cycle to confirm P0448 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$318 | $54–$756 |
| GBP | £15–£250 | £43–£602 |
| CAD | CA$26–CA$426 | CA$73–CA$1015 |
| EUR | €18–€294 | €50–€700 |
| CHF | CHF 21–CHF 338 | CHF 66–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0448?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0448?
DIY replacement parts average $19–$318, while professional service averages $54–$756.

### Will resetting P0448 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

