FaultCodes.org
P045COBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P045C Fault Code: EGR B Control Circuit Low

OBD-II P045C (EVAP Emissions Control): EGR B Control Circuit Low.

Quick AnswerHigh — Service Soon

OBD-II fault code P045C indicates EGR B Control Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$756.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Moderate (Intermediate)
System
EVAP Emissions Control
Professional Repair
$86 – $756

What This Fault Code Means

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. EGR B is a second EGR valve next to valve A – on diesels with two EGR circuits the low-pressure valve, which takes exhaust after the particulate filter and feeds it in before the turbo compressor. GM's diesels of 2016–18 and FCA's 2.2-litre diesel in the Jeep Wrangler use it. P045C means the drive circuit of valve B is shorted to ground (for valve A, P0489, GM uses 0.5 Ω or less with the driver off, MIL after two trips). The driver is switched off for protection and the valve stays in its rest position. GM lists this code among those that switch off the low-pressure EGR position control, but publishes no thresholds for it; the description follows the comparable valve A checks and CARB, which requires output circuits to be monitored.

Common Symptoms

  • Check engine light on
  • Low-pressure EGR switched off, possibly higher NOx
  • Usually no change in driving

Most Likely Root Causes

  • Control wire chafed against ground (engine, exhaust)
  • Actuator motor winding shorted
  • Water or corrosion in the connector
  • Driver in the engine module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P045C.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Egr Valve B.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P045C?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Egr Valve B.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Egr Valve B.
  5. 5Clear fault memory and run a verification cycle to confirm P045C does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$30 – $318
Professional Repair (Parts + Labor)$86 – $756

Frequently Asked Questions

Is it safe to keep operating with fault code P045C?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P045C?

DIY replacement parts average $30–$318, while professional service averages $86–$756.

Will resetting P045C fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P045C fault code meaningP045C repair costhow to fix P045C

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P045C Fault Code: EGR B Control Circuit Low — Causes, Fixes & Cost | FaultCodes.org