FaultCodes.org
P0445OBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P0445 Fault Code: EVAP System Purge Control Valve A Circuit Shorted

OBD-II P0445 (EVAP Emissions Control): EVAP System Purge Control Valve A Circuit Shorted.

Quick AnswerLow — Minor Issue

OBD-II fault code P0445 indicates EVAP System Purge Control Valve A Circuit Shorted. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Easy (Basic Tools)
System
EVAP Emissions Control
Professional Repair
$43 – $270

What This Fault Code Means

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0445 is the short-circuit code of the older scheme for purge valve A, used by Saab's Trionic T7 and VW; GM reports shorts as P0458/P0459, Ford covers them in P0443. Saab checks with the low-side output switched on: the voltage should then be near 0 V, and above 2 V means the line is shorted to positive or the coil is shorted, with the driver in current limiting. The code sets after about 1 s; the driver protects itself by switching off, so purging stops.

Common Symptoms

  • Check engine light on
  • Possibly fuel smell
  • EVAP monitors do not run

Most Likely Root Causes

  • Purge valve coil shorted (shorted turns)
  • Control wire shorted to positive (chafed)
  • Moisture or corrosion in the connector
  • Driver in the engine module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0445.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Evap Purge Valve.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0445?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Evap Purge Valve.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Evap Purge Valve.
  5. 5Clear fault memory and run a verification cycle to confirm P0445 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$16 – $113
Professional Repair (Parts + Labor)$43 – $270

Frequently Asked Questions

Is it safe to keep operating with fault code P0445?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0445?

DIY replacement parts average $16–$113, while professional service averages $43–$270.

Will resetting P0445 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0445 fault code meaningP0445 repair costhow to fix P0445

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P0445 Fault Code: EVAP System Purge Control Valve A Circuit Shorted | FaultCodes.org