FaultCodes.org
P0495OBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P0495 Fault Code: Fan 1 Overspeed

OBD-II P0495 (EVAP Emissions Control): Fan 1 Overspeed.

Quick AnswerLow — Minor Issue

OBD-II fault code P0495 indicates Fan 1 Overspeed. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $162–$864.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
EVAP Emissions Control
Professional Repair
$162 – $864

What This Fault Code Means

Two kinds of cooling fan carry these codes: electric fans switched by relays or driven by a PWM/LIN fan module with speed feedback, and engine-driven fans with an electronically controlled viscous clutch, whose speed a Hall sensor reports – GM calls them EV fans, meaning electro-viscous, not electric vehicle. P0495 mainly concerns viscous fans: with the fan commanded off it turns faster than the permitted drag speed, so the clutch does not release. GM thresholds: Duramax 2016 above 1500 rpm, Duramax 2018 above a calculated drag speed, petrol SUVs of 2004–05 above 1600 rpm without command – all with the warning lamp after two trips; Ford's 6.7-litre Super Duty uses it the same way. On GM's 2020 2.0-litre turbo with a LIN electric fan it means a reported speed above 2900 rpm.

Common Symptoms

  • Check engine light on
  • Loud fan roar even with a cold engine or at idle
  • Slightly higher consumption, longer warm-up

Most Likely Root Causes

  • Viscous clutch does not release (gummed, overfilled, seized)
  • Clutch solenoid or its control stuck open (short to positive, valve sticking)
  • Wrong speed signal (sensor, wiring, interference)
  • Electric fan: module runs uncontrolled at full speed or relay sticking

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0495.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Fan Clutch.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0495?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Fan Clutch.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Fan Clutch.
  5. 5Clear fault memory and run a verification cycle to confirm P0495 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$57 – $363
Professional Repair (Parts + Labor)$162 – $864

Frequently Asked Questions

Is it safe to keep operating with fault code P0495?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0495?

DIY replacement parts average $57–$363, while professional service averages $162–$864.

Will resetting P0495 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0495 fault code meaningP0495 repair costhow to fix P0495

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P0495 Fault Code: Fan 1 Overspeed — Causes, Fixes & Cost | FaultCodes.org