# OBD-II P0495: Fan 1 Overspeed

> **Quick Answer:** OBD-II fault code P0495 indicates Fan 1 Overspeed. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $162–$864.

- **URL:** https://faultcodes.org/automotive/obd2-p0495
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Two kinds of cooling fan carry these codes: electric fans switched by relays or driven by a PWM/LIN fan module with speed feedback, and engine-driven fans with an electronically controlled viscous clutch, whose speed a Hall sensor reports – GM calls them EV fans, meaning electro-viscous, not electric vehicle. P0495 mainly concerns viscous fans: with the fan commanded off it turns faster than the permitted drag speed, so the clutch does not release. GM thresholds: Duramax 2016 above 1500 rpm, Duramax 2018 above a calculated drag speed, petrol SUVs of 2004–05 above 1600 rpm without command – all with the warning lamp after two trips; Ford's 6.7-litre Super Duty uses it the same way. On GM's 2020 2.0-litre turbo with a LIN electric fan it means a reported speed above 2900 rpm.

## Common Symptoms
- Check engine light on
- Loud fan roar even with a cold engine or at idle
- Slightly higher consumption, longer warm-up

## Most Likely Root Causes
- Viscous clutch does not release (gummed, overfilled, seized)
- Clutch solenoid or its control stuck open (short to positive, valve sticking)
- Wrong speed signal (sensor, wiring, interference)
- Electric fan: module runs uncontrolled at full speed or relay sticking

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fan Clutch.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fan Clutch.
5. Clear fault memory and run a verification cycle to confirm P0495 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $57–$363 | $162–$864 |
| GBP | £45–£286 | £129–£688 |
| CAD | CA$77–CA$487 | CA$218–CA$1160 |
| EUR | €53–€336 | €150–€800 |
| CHF | CHF 61–CHF 386 | CHF 198–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0495?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0495?
DIY replacement parts average $57–$363, while professional service averages $162–$864.

### Will resetting P0495 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

