P0457 Fault Code: EVAP System Leak Detected (fuel cap loose/off)
OBD-II P0457 (EVAP Emissions Control): EVAP System Leak Detected (fuel cap loose/off).
OBD-II fault code P0457 indicates EVAP System Leak Detected (fuel cap loose/off). Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$108.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Easy (Basic Tools)
- System
- EVAP Emissions Control
- Professional Repair
- $43 – $108
What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0457 is a large leak attributed to the fuel cap: Ford detects refuelling and treats a vacuum that is not reached afterwards (about −2 kPa in 30 s) as an open cap. CARB allows a separate check fuel cap lamp instead of the warning lamp, and the code is cleared once the cap is found tight again. Ford sets the lamp after two to three trips depending on calibration, Subaru after two. GM and Saab's ME9 do not use the code.
Common Symptoms
- Check fuel cap lamp or check engine light on
- Fuel smell
- EVAP readiness not set
Most Likely Root Causes
- Fuel cap not closed, not clicked in or forgotten
- Fuel cap seal faulty or non-original cap
- Filler neck sealing surface damaged or capless flap sticking
- Vent valve stuck open
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0457.
- 2Inspect electrical connectors, fuses, and harnesses connected to Fuel Cap.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0457?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Fuel Cap.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Fuel Cap.
- 5Clear fault memory and run a verification cycle to confirm P0457 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $16 – $49 |
| Professional Repair (Parts + Labor) | $43 – $108 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0457?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P0457?
DIY replacement parts average $16–$49, while professional service averages $43–$108.
Will resetting P0457 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (EVAP Emissions Control)