P044E Fault Code: EGR Sensor C Circuit Intermittent/Erratic
OBD-II P044E (EVAP Emissions Control): EGR Sensor C Circuit Intermittent/Erratic.
OBD-II fault code P044E indicates EGR Sensor C Circuit Intermittent/Erratic. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Easy (Basic Tools)
- System
- EVAP Emissions Control
- Professional Repair
- $43 – $270
What This Fault Code Means
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. What EGR sensor C is depends on the maker: on Ford petrol engines from 2020 it is the DPFE sensor, which measures the pressure drop across an orifice in the EGR pipe (sensor A there is the valve position sensor); GM diesels assign it to the position sensor of a low-pressure EGR valve, but only within fault groups. P044E means short dropouts or jumps in its signal, too brief for P044C/P044D or with an impossible rate of change. No manufacturer document available to us uses this code; Ford applies the same idea to sensor A as P046D, where a limit violation of only 0.4 s counts. EGR diagnosis is then suspended.
Common Symptoms
- Check engine light on, may come and go
- Usually no driving symptom
- Code returns after clearing
Most Likely Root Causes
- Loose contact in the connector or broken wire
- Condensate in the sensor or hose (DPFE)
- Sensor unstable internally
- Interference or ground problems
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P044E.
- 2Inspect electrical connectors, fuses, and harnesses connected to Egr Sensor C.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P044E?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Egr Sensor C.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Egr Sensor C.
- 5Clear fault memory and run a verification cycle to confirm P044E does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $16 – $113 |
| Professional Repair (Parts + Labor) | $43 – $270 |
Frequently Asked Questions
Is it safe to keep operating with fault code P044E?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P044E?
DIY replacement parts average $16–$113, while professional service averages $43–$270.
Will resetting P044E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (EVAP Emissions Control)