FaultCodes.org
P0459OBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P0459 Fault Code: EVAP System Purge Control Valve A Circuit High

OBD-II P0459 (EVAP Emissions Control): EVAP System Purge Control Valve A Circuit High.

Quick AnswerLow — Minor Issue

OBD-II fault code P0459 indicates EVAP System Purge Control Valve A Circuit High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$216.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Easy (Basic Tools)
System
EVAP Emissions Control
Professional Repair
$43 – $216

What This Fault Code Means

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Purge valve A is switched to ground by the module and fed from the main relay. P0459 means its control wire is shorted to positive, detected with the driver switched on, when the line should sit at ground (GM 20 of 25 samples, MIL after two trips; Saab ME9 above 4.6 V). The valve then cannot open, the canister is not purged and fills up; the driver protects itself and the leak tests are suspended.

Common Symptoms

  • Check engine light on
  • Fuel smell when the canister is full
  • EVAP readiness not set

Most Likely Root Causes

  • Control wire shorted to battery voltage or supply
  • Purge valve coil low-resistance (shorted turns)
  • Connector or harness damaged
  • Engine module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0459.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Evap Purge Valve.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0459?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Evap Purge Valve.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Evap Purge Valve.
  5. 5Clear fault memory and run a verification cycle to confirm P0459 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$16 – $91
Professional Repair (Parts + Labor)$43 – $216

Frequently Asked Questions

Is it safe to keep operating with fault code P0459?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0459?

DIY replacement parts average $16–$91, while professional service averages $43–$216.

Will resetting P0459 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0459 fault code meaningP0459 repair costhow to fix P0459

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P0459 Fault Code: EVAP System Purge Control Valve A Circuit High | FaultCodes.org