FaultCodes.org
P044FOBD-IIEVAP Emissions ControlTechnical Reference· Updated: Nov 22, 2026

P044F Fault Code: AIR System Switching Valve A Circuit High

OBD-II P044F (EVAP Emissions Control): AIR System Switching Valve A Circuit High.

Quick AnswerLow — Minor Issue

OBD-II fault code P044F indicates AIR System Switching Valve A Circuit High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$324.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Easy (Basic Tools)
System
EVAP Emissions Control
Professional Repair
$43 – $324

What This Fault Code Means

After a cold start the secondary air pump blows fresh air into the exhaust; switching valve A is the electrically driven valve that opens this path. GM checks the valve circuit in three codes – P0412 open, P041F shorted to ground, P044F shorted to positive – while other makers use P0413/P0414 or P0412 for everything. P044F means the control circuit is shorted to positive or the coil is low-resistance: when the driver switches on, the line stays high. GM sets the code at 0.5 Ω or less to the supply (20 of 25 samples of 250 ms, above 11 V, MIL after two trips). The valve then does not open, secondary air is missing and P0411 may follow.

Common Symptoms

  • Check engine light on (after two trips)
  • No change in driving
  • Secondary air readiness not set, possibly P0411

Most Likely Root Causes

  • Valve coil shorted internally (low resistance)
  • Control wire chafed against a supply wire
  • Water in the connector bridging to the supply
  • Driver in the engine module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P044F.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Air Switching Valve A.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P044F?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Air Switching Valve A.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Air Switching Valve A.
  5. 5Clear fault memory and run a verification cycle to confirm P044F does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$16 – $136
Professional Repair (Parts + Labor)$43 – $324

Frequently Asked Questions

Is it safe to keep operating with fault code P044F?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P044F?

DIY replacement parts average $16–$136, while professional service averages $43–$324.

Will resetting P044F fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P044F fault code meaningP044F repair costhow to fix P044F

Manufacturer & Technical Reference

OBD-II Technical Reference (EVAP Emissions Control)

Related Fault Codes

Auto & OBD-II →
P044F Fault Code: AIR System Switching Valve A Circuit High | FaultCodes.org