FaultCodes.org

Automotive & OBD-II

Diagnostic trouble codes (P, B, C, U) for Ford, Toyota, BMW, VW, GM, and generic SAE J2012 vehicles with repair cost ranges.

18,923 codes indexed
P0741OBD-II

OBD-II P0741: Torque Converter Clutch (TCC) Circuit Performance / Stuck Off

Torque Converter Clutch fails to mechanically lock at highway cruise—live transmission telemetry shows TCC Slip RPM well above `~0 RPM` (typically `> 50–200 RPM` slip while commanded ON); inspect burnt/low ATF fluid first, then TCC solenoid (`~10–25 Ω`), worn valve-body bore, or converter clutch lining.

P2135OBD-II

OBD-II P2135: Throttle / Pedal Position Sensor / Switch "A" / "B" Voltage Correlation

Drive-by-wire Electronic Throttle Body dual TPS tracks diverge (`TPS1 ~0.5->4.5 V` vs `TPS2 ~4.5->0.5 V` on `5.0 V` ref), triggering instant Reduced Engine Power / Limp Mode—check battery voltage (`P0562`) and corroded throttle pigtails before replacing the ETB + performing Idle Relearn.

P2138OBD-II

OBD-II P2138: Throttle / Accelerator Pedal Position Sensor / Switch "D" / "E" Voltage Correlation

Dual Accelerator Pedal Position (`APP`) sensors inside the cabin gas pedal disagree across their `5.0 V` reference slopes, forcing immediate Limp Mode / dead throttle—check wet floor-mat corrosion at the pedal plug, `5.0 V` ref drop, and smooth `APP1 / APP2` live sweeps first.

P2195OBD-II

OBD-II P2195: O2 Sensor Signal Biased / Stuck Lean (Bank 1 Sensor 1)

Wideband A/F pump current (`Ip`) or Nernst cell signal on `B1S1` remains stuck lean (`λ > 1.05–1.10`) despite maxed positive `STFT` enrichment—run a brief fuel-enrichment test to separate massive vacuum/exhaust leaks or low fuel pressure from a dead wideband A/F sensor or open signal wire.

U0101OBD-II

OBD-II U0101: Lost Communication With Transmission Control Module (TCM)

ECM/ABS/cluster lost high-speed CAN bus messages from the `TCM`—verify battery health (`12.6 V` KOEO / `13.5–14.5 V` running) and TCM fuses/grounds FIRST, then with battery negative disconnected measure OBD-II Pin 6 (`CAN-H`) to Pin 14 (`CAN-L`) = `60 Ω`, inspect fluid-wicked TCM connectors, and test wake-up feed.

P0010OBD-II

OBD-II P0010: "A" Camshaft Position Actuator Circuit / Open (Bank 1)

Pure electrical open or short in the Bank 1 intake (`"A"`) VVT Oil Control Valve (`OCV`) solenoid circuit—ohm-test the unplugged coil (`6.0–12.0 Ω` @ `20 °C`, `OL` to housing ground), check oil-wicked connectors & `12 V` fuse, and confirm PCM PWM ground pulse before replacing the OCV.

P0017OBD-II

OBD-II P0017: Crankshaft Position – Camshaft Position Correlation (Bank 1 Sensor B)

Mechanical timing phase mismatch between crankshaft (`CKP`) and Bank 1 exhaust (`"B"`) camshaft (`CMP`)—STOP aggressive driving on interference engines (valve-to-piston risk); check oil level/sludge & exhaust VVT OCV (`6–12 Ω`) first, then diagnose stretched timing chain, slipped exhaust phaser/tone wheel, or failed tensioner via oscilloscope.

P0001OBD-II

Fuel Volume Regulator A Control Circuit/Open

OBD-II P0001: Fuel Volume Regulator A Control Circuit/Open

P0002OBD-II

Fuel Volume Regulator A Control Circuit Range/Performance

OBD-II P0002: Fuel Volume Regulator A Control Circuit Range/Performance

P0003OBD-II

Fuel Volume Regulator A Control Circuit Low

OBD-II P0003: Fuel Volume Regulator A Control Circuit Low

P0004OBD-II

Fuel Volume Regulator A Control Circuit High

OBD-II P0004: Fuel Volume Regulator A Control Circuit High

P0005OBD-II

Fuel Shutoff Valve A Control Circuit/Open

OBD-II P0005: Fuel Shutoff Valve A Control Circuit/Open

P0006OBD-II

Fuel Shutoff Valve A Control Circuit Low

OBD-II P0006: Fuel Shutoff Valve A Control Circuit Low

P0007OBD-II

Fuel Shutoff Valve A Control Circuit High

OBD-II P0007: Fuel Shutoff Valve A Control Circuit High

P0008OBD-II

Engine Position System Performance Bank 1

OBD-II P0008: Engine Position System Performance Bank 1

P0009OBD-II

Engine Position System Performance Bank 2

OBD-II P0009: Engine Position System Performance Bank 2

P000AOBD-II

A Camshaft Position Slow Response Bank 1

OBD-II P000A: A Camshaft Position Slow Response Bank 1

P000BOBD-II

B Camshaft Position Slow Response Bank 1

OBD-II P000B: B Camshaft Position Slow Response Bank 1

P000COBD-II

A Camshaft Position Slow Response Bank 2

OBD-II P000C: A Camshaft Position Slow Response Bank 2

P000DOBD-II

B Camshaft Position Slow Response Bank 2

OBD-II P000D: B Camshaft Position Slow Response Bank 2

P000EOBD-II

Fuel Volume Regulator Control Exceeded Learning Limit

OBD-II P000E: Fuel Volume Regulator Control Exceeded Learning Limit

P000FOBD-II

Fuel System Over Pressure Relief Valve Activated

OBD-II P000F: Fuel System Over Pressure Relief Valve Activated

P0012OBD-II

"A" Camshaft Position - Timing Over-Retarded (Bank 1)

OBD-II P0012: "A" Camshaft Position - Timing Over-Retarded (Bank 1)

P0013OBD-II

"B" Camshaft Position Actuator Circuit (Bank 1)

OBD-II P0013: "B" Camshaft Position Actuator Circuit (Bank 1)

P0015OBD-II

"B" Camshaft Position - Timing Over-Retarded (Bank 1)

OBD-II P0015: "B" Camshaft Position - Timing Over-Retarded (Bank 1)

P0018OBD-II

Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A)

OBD-II P0018: Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A)

P0019OBD-II

Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor B)

OBD-II P0019: Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor B)

P001AOBD-II

A Camshaft Profile Actuator A Control Circuit/Open Bank 1

OBD-II P001A: A Camshaft Profile Actuator A Control Circuit/Open Bank 1

P001BOBD-II

A Camshaft Profile Actuator A Control Circuit Low Bank 1

OBD-II P001B: A Camshaft Profile Actuator A Control Circuit Low Bank 1

P001COBD-II

A Camshaft Profile Actuator A Control Circuit High Bank 1

OBD-II P001C: A Camshaft Profile Actuator A Control Circuit High Bank 1

P001DOBD-II

A Camshaft Profile Actuator A Control Circuit/Open Bank 2

OBD-II P001D: A Camshaft Profile Actuator A Control Circuit/Open Bank 2

P001EOBD-II

A Camshaft Profile Actuator A Control Circuit Low Bank 2

OBD-II P001E: A Camshaft Profile Actuator A Control Circuit Low Bank 2

P001FOBD-II

A Camshaft Profile Actuator A Control Circuit High Bank 2

OBD-II P001F: A Camshaft Profile Actuator A Control Circuit High Bank 2

P0020OBD-II

"A" Camshaft Position Actuator Circuit (Bank 2)

OBD-II P0020: "A" Camshaft Position Actuator Circuit (Bank 2)

P0021OBD-II

"A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)

OBD-II P0021: "A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)

P0022OBD-II

"A" Camshaft Position - Timing Over-Retarded (Bank 2)

OBD-II P0022: "A" Camshaft Position - Timing Over-Retarded (Bank 2)

P0023OBD-II

"B" Camshaft Position Actuator Circuit (Bank 2)

OBD-II P0023: "B" Camshaft Position Actuator Circuit (Bank 2)

P0024OBD-II

"B" Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)

OBD-II P0024: "B" Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)

P0025OBD-II

"B" Camshaft Position - Timing Over-Retarded (Bank 2)

OBD-II P0025: "B" Camshaft Position - Timing Over-Retarded (Bank 2)

P0026OBD-II

Intake Valve Control Solenoid Circuit Range/Performance (Bank 1)

OBD-II P0026: Intake Valve Control Solenoid Circuit Range/Performance (Bank 1)

P0027OBD-II

Exhaust Valve Control Solenoid Circuit Range/Performance (Bank 1)

OBD-II P0027: Exhaust Valve Control Solenoid Circuit Range/Performance (Bank 1)

P0028OBD-II

Intake Valve Control Solenoid Circuit Range/Performance (Bank 2)

OBD-II P0028: Intake Valve Control Solenoid Circuit Range/Performance (Bank 2)

P0029OBD-II

Exhaust Valve Control Solenoid Circuit Range/Performance (Bank 2)

OBD-II P0029: Exhaust Valve Control Solenoid Circuit Range/Performance (Bank 2)

P002AOBD-II

B Camshaft Profile Actuator A Control Circuit/Open Bank 1

OBD-II P002A: B Camshaft Profile Actuator A Control Circuit/Open Bank 1

P002BOBD-II

B Camshaft Profile Actuator A Control Circuit Low Bank 1

OBD-II P002B: B Camshaft Profile Actuator A Control Circuit Low Bank 1

P002COBD-II

B Camshaft Profile Actuator A Control Circuit High Bank 1

OBD-II P002C: B Camshaft Profile Actuator A Control Circuit High Bank 1

P002DOBD-II

B Camshaft Profile Actuator A Control Circuit/Open Bank 2

OBD-II P002D: B Camshaft Profile Actuator A Control Circuit/Open Bank 2

P002EOBD-II

B Camshaft Profile Actuator A Control Circuit Low Bank 2

OBD-II P002E: B Camshaft Profile Actuator A Control Circuit Low Bank 2

Automotive & OBD-II (Page 2) — FaultCodes.org | FaultCodes.org