P0006 Fault Code: Fuel Shutoff Valve A Control Circuit Low
OBD-II P0006 (Powertrain & Engine Management): Fuel Shutoff Valve A Control Circuit Low.
OBD-II fault code P0006 indicates Fuel Shutoff Valve A Control Circuit Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$324.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- Powertrain & Engine Management
- Professional Repair
- $54 – $324
What This Fault Code Means
The fuel shutoff valve is a solenoid valve that opens or blocks the fuel supply. On diesel engines it is usually closed without current, so that the engine stops reliably when switched off. The engine control module energises it to let fuel flow and monitors its control circuit continuously. P0006 means voltage or current in the control circuit is below the expected range, typically because of a short to ground; depending on the output stage an open circuit can also show up this way. The valve is then not energised correctly, which can prevent starting or make the engine stall.
Common Symptoms
- Check engine light on
- Hard starting or no start
- Engine stalls
Most Likely Root Causes
- Short to ground in the harness
- Shorted turns in the valve coil
- Corroded connector
- Output driver in the engine control module faulty
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0006.
- 2Inspect electrical connectors, fuses, and harnesses connected to Fuel Shutoff Valve.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0006?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Fuel Shutoff Valve.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Fuel Shutoff Valve.
- 5Clear fault memory and run a verification cycle to confirm P0006 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $19 – $136 |
| Professional Repair (Parts + Labor) | $54 – $324 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0006?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair P0006?
DIY replacement parts average $19–$136, while professional service averages $54–$324.
Will resetting P0006 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Powertrain & Engine Management)