# OBD-II P0006: Fuel Shutoff Valve A Control Circuit Low

> **Quick Answer:** OBD-II fault code P0006 indicates Fuel Shutoff Valve A Control Circuit Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0006
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The fuel shutoff valve is a solenoid valve that opens or blocks the fuel supply. On diesel engines it is usually closed without current, so that the engine stops reliably when switched off. The engine control module energises it to let fuel flow and monitors its control circuit continuously. P0006 means voltage or current in the control circuit is below the expected range, typically because of a short to ground; depending on the output stage an open circuit can also show up this way. The valve is then not energised correctly, which can prevent starting or make the engine stall.

## Common Symptoms
- Check engine light on
- Hard starting or no start
- Engine stalls

## Most Likely Root Causes
- Short to ground in the harness
- Shorted turns in the valve coil
- Corroded connector
- Output driver in the engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fuel Shutoff Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fuel Shutoff Valve.
5. Clear fault memory and run a verification cycle to confirm P0006 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$136 | $54–$324 |
| GBP | £15–£107 | £43–£258 |
| CAD | CA$26–CA$183 | CA$73–CA$435 |
| EUR | €18–€126 | €50–€300 |
| CHF | CHF 21–CHF 145 | CHF 66–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0006?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0006?
DIY replacement parts average $19–$136, while professional service averages $54–$324.

### Will resetting P0006 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

