P001F Fault Code: A Camshaft Profile Actuator A Control Circuit High Bank 2
OBD-II P001F (Powertrain & Engine Management): A Camshaft Profile Actuator A Control Circuit High Bank 2.
OBD-II fault code P001F indicates A Camshaft Profile Actuator A Control Circuit High Bank 2. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$540.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Powertrain & Engine Management
- Professional Repair
- $54 – $540
What This Fault Code Means
A camshaft profile actuator switches the intake camshaft (camshaft A) on bank 2 between two or more fixed cam profiles with different valve lift and duration, for example by shifting a cam piece axially or by locking rocker arms or tappets with oil pressure. Unlike a camshaft phaser it does not shift the timing continuously. The second letter "A" in the title numbers the actuator on this camshaft. This code is set when the control circuit reads too high, typically because of a short to battery voltage or overcurrent in the output stage. The engine usually stays on one profile, typically the base profile with low lift. Some manufacturers report these faults with their own codes instead. Bank 2 exists only on V and boxer engines.
Common Symptoms
- Check engine light on
- Less power at high engine speed because the profile does not switch
- Higher consumption or uneven part-load running, depending on the profile
- Engine speed may be limited
Most Likely Root Causes
- Control wire shorted to battery voltage
- Actuator coil shorted, causing overcurrent
- Connector corroded or contaminated with oil
- Output driver in the engine control module faulty
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P001F.
- 2Inspect electrical connectors, fuses, and harnesses connected to Camshaft Profile Actuator Intake Bank2.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P001F?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Camshaft Profile Actuator Intake Bank2.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Camshaft Profile Actuator Intake Bank2.
- 5Clear fault memory and run a verification cycle to confirm P001F does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $19 – $227 |
| Professional Repair (Parts + Labor) | $54 – $540 |
Frequently Asked Questions
Is it safe to keep operating with fault code P001F?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P001F?
DIY replacement parts average $19–$227, while professional service averages $54–$540.
Will resetting P001F fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Powertrain & Engine Management)