FaultCodes.org
P0007OBD-IIPowertrain & Engine ManagementTechnical Reference· Updated: Nov 22, 2026

P0007 Fault Code: Fuel Shutoff Valve A Control Circuit High

OBD-II P0007 (Powertrain & Engine Management): Fuel Shutoff Valve A Control Circuit High.

Quick AnswerModerate — Plan Repair

OBD-II fault code P0007 indicates Fuel Shutoff Valve A Control Circuit High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$324.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
Powertrain & Engine Management
Professional Repair
$54 – $324

What This Fault Code Means

The fuel shutoff valve is a solenoid valve that opens or blocks the fuel supply. On diesel engines it is usually closed without current, so that the engine stops reliably when switched off. The engine control module energises it to let fuel flow and monitors its control circuit continuously. P0007 means the voltage in the control circuit stays too high, because the control module expects the line to be pulled to ground. Typical causes are a short to battery voltage or, with ground-side switching, an open circuit. The valve cannot be switched, which leads to starting problems or stalling.

Common Symptoms

  • Check engine light on
  • Hard starting or no start
  • Engine stalls

Most Likely Root Causes

  • Control wire open or shorted to battery voltage
  • Valve coil open
  • Connector fault at the valve
  • Output driver in the engine control module faulty

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0007.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Fuel Shutoff Valve.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0007?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Fuel Shutoff Valve.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Fuel Shutoff Valve.
  5. 5Clear fault memory and run a verification cycle to confirm P0007 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $136
Professional Repair (Parts + Labor)$54 – $324

Frequently Asked Questions

Is it safe to keep operating with fault code P0007?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0007?

DIY replacement parts average $19–$136, while professional service averages $54–$324.

Will resetting P0007 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0007 fault code meaningP0007 repair costhow to fix P0007

Manufacturer & Technical Reference

OBD-II Technical Reference (Powertrain & Engine Management)

Related Fault Codes

Auto & OBD-II →
P0007 Fault Code: Fuel Shutoff Valve A Control Circuit High | FaultCodes.org