FaultCodes.org
P0004OBD-IIPowertrain & Engine ManagementTechnical Reference· Updated: Nov 22, 2026

P0004 Fault Code: Fuel Volume Regulator A Control Circuit High

OBD-II P0004 (Powertrain & Engine Management): Fuel Volume Regulator A Control Circuit High.

Quick AnswerHigh — Service Soon

OBD-II fault code P0004 indicates Fuel Volume Regulator A Control Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$2700.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Moderate (Intermediate)
System
Powertrain & Engine Management
Professional Repair
$86 – $2,700

What This Fault Code Means

The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0004 means the voltage on the control circuit stays too high for the commanded duty cycle, typically because of a short to battery voltage, or, with a switched ground side, an open circuit. The valve can then not be energised; a normally open design delivers maximum fuel and rail pressure rises.

Common Symptoms

  • Check engine light on
  • Loss of power or limp mode
  • Rough running or diesel knock possible
  • Excess rail pressure codes possible

Most Likely Root Causes

  • Short to battery voltage in the harness
  • Open coil or wire, reported as high with ground-side switching
  • Connector fault at the regulator
  • Output driver in the engine control module faulty

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0004.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Fuel Volume Regulator.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0004?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Fuel Volume Regulator.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Fuel Volume Regulator.
  5. 5Clear fault memory and run a verification cycle to confirm P0004 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$30 – $1,134
Professional Repair (Parts + Labor)$86 – $2,700

Frequently Asked Questions

Is it safe to keep operating with fault code P0004?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P0004?

DIY replacement parts average $30–$1134, while professional service averages $86–$2700.

Will resetting P0004 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0004 fault code meaningP0004 repair costhow to fix P0004

Manufacturer & Technical Reference

OBD-II Technical Reference (Powertrain & Engine Management)

Related Fault Codes

Auto & OBD-II →
P0004 Fault Code: Fuel Volume Regulator A Control Circuit High | FaultCodes.org