# OBD-II P0004: Fuel Volume Regulator A Control Circuit High

> **Quick Answer:** OBD-II fault code P0004 indicates Fuel Volume Regulator A Control Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$2700.

- **URL:** https://faultcodes.org/automotive/obd2-p0004
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0004 means the voltage on the control circuit stays too high for the commanded duty cycle, typically because of a short to battery voltage, or, with a switched ground side, an open circuit. The valve can then not be energised; a normally open design delivers maximum fuel and rail pressure rises.

## Common Symptoms
- Check engine light on
- Loss of power or limp mode
- Rough running or diesel knock possible
- Excess rail pressure codes possible

## Most Likely Root Causes
- Short to battery voltage in the harness
- Open coil or wire, reported as high with ground-side switching
- Connector fault at the regulator
- Output driver in the engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fuel Volume Regulator.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fuel Volume Regulator.
5. Clear fault memory and run a verification cycle to confirm P0004 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$1134 | $86–$2700 |
| GBP | £24–£893 | £69–£2150 |
| CAD | CA$41–CA$1523 | CA$116–CA$3625 |
| EUR | €28–€1050 | €80–€2500 |
| CHF | CHF 32–CHF 1208 | CHF 106–CHF 3300 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0004?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0004?
DIY replacement parts average $30–$1134, while professional service averages $86–$2700.

### Will resetting P0004 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

