P0022 Fault Code: "A" Camshaft Position - Timing Over-Retarded (Bank 2)
OBD-II P0022 (Powertrain & Engine Management): "A" Camshaft Position - Timing Over-Retarded (Bank 2).
OBD-II fault code P0022 indicates "A" Camshaft Position - Timing Over-Retarded (Bank 2). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$2700.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Powertrain & Engine Management
- Professional Repair
- $65 – $2,700
What This Fault Code Means
The engine control module compares the commanded position of the intake camshaft on bank 2 with the actual position from the camshaft and crankshaft sensors. This code is set when the camshaft stays further retarded than commanded for longer than a calibrated time. Usually the phaser does not move far enough out of its rest position, because oil pressure is too low to release the locking pin, the oil control valve does not open, or the oil screen is blocked. A stretched timing chain also shifts the camshaft towards retarded. Bank 2 exists only on V and boxer engines; it is the cylinder bank without cylinder 1.
Common Symptoms
- Check engine light on
- Noticeably less torque and pulling power
- Higher fuel consumption
- Harder starting in some cases
- Rattle from the timing drive if the chain is stretched
Most Likely Root Causes
- Oil pressure or oil level too low, oil worn out
- Oil control valve sticking closed or its screen blocked
- Cam phaser defective or seized in its rest position
- Timing chain stretched or jumped a tooth
- Wear debris in the oil circuit, e.g. from a thrust bearing
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0022.
- 2Inspect electrical connectors, fuses, and harnesses connected to Cam Phaser Intake Bank2.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0022?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Cam Phaser Intake Bank2.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Cam Phaser Intake Bank2.
- 5Clear fault memory and run a verification cycle to confirm P0022 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $1,134 |
| Professional Repair (Parts + Labor) | $65 – $2,700 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0022?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P0022?
DIY replacement parts average $23–$1134, while professional service averages $65–$2700.
Will resetting P0022 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Powertrain & Engine Management)