# OBD-II P0022: "A" Camshaft Position - Timing Over-Retarded (Bank 2)

> **Quick Answer:** OBD-II fault code P0022 indicates "A" Camshaft Position - Timing Over-Retarded (Bank 2). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$2700.

- **URL:** https://faultcodes.org/automotive/obd2-p0022
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine control module compares the commanded position of the intake camshaft on bank 2 with the actual position from the camshaft and crankshaft sensors. This code is set when the camshaft stays further retarded than commanded for longer than a calibrated time. Usually the phaser does not move far enough out of its rest position, because oil pressure is too low to release the locking pin, the oil control valve does not open, or the oil screen is blocked. A stretched timing chain also shifts the camshaft towards retarded. Bank 2 exists only on V and boxer engines; it is the cylinder bank without cylinder 1.

## Common Symptoms
- Check engine light on
- Noticeably less torque and pulling power
- Higher fuel consumption
- Harder starting in some cases
- Rattle from the timing drive if the chain is stretched

## Most Likely Root Causes
- Oil pressure or oil level too low, oil worn out
- Oil control valve sticking closed or its screen blocked
- Cam phaser defective or seized in its rest position
- Timing chain stretched or jumped a tooth
- Wear debris in the oil circuit, e.g. from a thrust bearing

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Cam Phaser Intake Bank2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Cam Phaser Intake Bank2.
5. Clear fault memory and run a verification cycle to confirm P0022 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$1134 | $65–$2700 |
| GBP | £18–£893 | £52–£2150 |
| CAD | CA$30–CA$1523 | CA$87–CA$3625 |
| EUR | €21–€1050 | €60–€2500 |
| CHF | CHF 24–CHF 1208 | CHF 79–CHF 3300 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0022?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0022?
DIY replacement parts average $23–$1134, while professional service averages $65–$2700.

### Will resetting P0022 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

