FaultCodes.org
P0008OBD-IIPowertrain & Engine ManagementTechnical Reference· Updated: Nov 22, 2026

P0008 Fault Code: Engine Position System Performance Bank 1

OBD-II P0008 (Powertrain & Engine Management): Engine Position System Performance Bank 1.

Quick AnswerModerate — Plan Repair

OBD-II fault code P0008 indicates Engine Position System Performance Bank 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $1620–$4320.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
Powertrain & Engine Management
Professional Repair
$1,620 – $4,320

What This Fault Code Means

The engine control module learns how far each camshaft of bank 1 is offset from the crankshaft and compares this with a reference. P0008 is set when both camshafts of this bank are shifted in the same direction beyond a threshold. That points to the drive shared by the bank: a stretched primary timing chain, a worn tensioner, an idler gear or a crankshaft reluctor wheel that has slipped. A single faulty camshaft phaser does not set this code, because it affects only one camshaft.

Common Symptoms

  • Check engine light on
  • Timing chain rattle, especially at cold start
  • Loss of power or rough running
  • Often stored together with P0016 to P0019

Most Likely Root Causes

  • Primary or timing chain stretched
  • Chain tensioner worn or loose
  • Timing drive fitted incorrectly after an engine repair
  • Crankshaft reluctor wheel slipped

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0008.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Timing Chain.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0008?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Timing Chain.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Timing Chain.
  5. 5Clear fault memory and run a verification cycle to confirm P0008 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$567 – $1,814
Professional Repair (Parts + Labor)$1,620 – $4,320

Frequently Asked Questions

Is it safe to keep operating with fault code P0008?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair P0008?

DIY replacement parts average $567–$1814, while professional service averages $1620–$4320.

Will resetting P0008 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0008 fault code meaningP0008 repair costhow to fix P0008

Manufacturer & Technical Reference

OBD-II Technical Reference (Powertrain & Engine Management)

Related Fault Codes

Auto & OBD-II →
P0008 Fault Code: Engine Position System Performance Bank 1 | FaultCodes.org