# OBD-II P0008: Engine Position System Performance Bank 1

> **Quick Answer:** OBD-II fault code P0008 indicates Engine Position System Performance Bank 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $1620–$4320.

- **URL:** https://faultcodes.org/automotive/obd2-p0008
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine control module learns how far each camshaft of bank 1 is offset from the crankshaft and compares this with a reference. P0008 is set when both camshafts of this bank are shifted in the same direction beyond a threshold. That points to the drive shared by the bank: a stretched primary timing chain, a worn tensioner, an idler gear or a crankshaft reluctor wheel that has slipped. A single faulty camshaft phaser does not set this code, because it affects only one camshaft.

## Common Symptoms
- Check engine light on
- Timing chain rattle, especially at cold start
- Loss of power or rough running
- Often stored together with P0016 to P0019

## Most Likely Root Causes
- Primary or timing chain stretched
- Chain tensioner worn or loose
- Timing drive fitted incorrectly after an engine repair
- Crankshaft reluctor wheel slipped

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Timing Chain.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Timing Chain.
5. Clear fault memory and run a verification cycle to confirm P0008 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $567–$1814 | $1620–$4320 |
| GBP | £446–£1428 | £1290–£3440 |
| CAD | CA$761–CA$2436 | CA$2175–CA$5800 |
| EUR | €525–€1680 | €1500–€4000 |
| CHF | CHF 604–CHF 1932 | CHF 1980–CHF 5280 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0008?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0008?
DIY replacement parts average $567–$1814, while professional service averages $1620–$4320.

### Will resetting P0008 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

