P0013 Fault Code: "B" Camshaft Position Actuator Circuit (Bank 1)
OBD-II P0013 (Powertrain & Engine Management): "B" Camshaft Position Actuator Circuit (Bank 1).
OBD-II fault code P0013 indicates "B" Camshaft Position Actuator Circuit (Bank 1). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$324.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Moderate (Intermediate)
- System
- Powertrain & Engine Management
- Professional Repair
- $54 – $324
What This Fault Code Means
The engine control module drives the oil control valve (a pulse-width modulated solenoid) of the variable valve timing on the exhaust camshaft on bank 1. It checks the electrical state of this output and sets the code when the circuit is open, or when the measured state does not match the command, for example because of a short. Camshaft adjustment is then disabled and the phaser stays in its locked rest position: the engine keeps running, but with less torque and higher consumption. Bank 1 is the cylinder bank that contains cylinder 1.
Common Symptoms
- Check engine light on
- Less pulling power at low and medium engine speed
- Rough idle in some engines
- Slightly higher fuel consumption
Most Likely Root Causes
- Solenoid coil of the oil control valve open or shorted
- Connector corroded, loose or soaked with engine oil wicking through the valve
- Wiring harness chafed through or broken
- Supply voltage missing, e.g. blown fuse
- Output driver in the engine control module faulty
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside P0013.
- 2Inspect electrical connectors, fuses, and harnesses connected to Oil Control Valve Exhaust Bank1.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside P0013?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Oil Control Valve Exhaust Bank1.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Oil Control Valve Exhaust Bank1.
- 5Clear fault memory and run a verification cycle to confirm P0013 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $19 – $136 |
| Professional Repair (Parts + Labor) | $54 – $324 |
Frequently Asked Questions
Is it safe to keep operating with fault code P0013?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair P0013?
DIY replacement parts average $19–$136, while professional service averages $54–$324.
Will resetting P0013 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (Powertrain & Engine Management)