FaultCodes.org
P0003OBD-IIPowertrain & Engine ManagementTechnical Reference· Updated: Nov 22, 2026

P0003 Fault Code: Fuel Volume Regulator A Control Circuit Low

OBD-II P0003 (Powertrain & Engine Management): Fuel Volume Regulator A Control Circuit Low.

Quick AnswerHigh — Service Soon

OBD-II fault code P0003 indicates Fuel Volume Regulator A Control Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$2700.

Safe to Operate?
No — Risk of Damage
DIY Difficulty
Moderate (Intermediate)
System
Powertrain & Engine Management
Professional Repair
$86 – $2,700

What This Fault Code Means

The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0003 means the control module measures a voltage or current below the expected range on the control circuit, typically because of a short to ground. On some output stages an open circuit is also reported as low. A short on the switched ground side can keep the valve permanently energised.

Common Symptoms

  • Check engine light on
  • Hard starting or stalling
  • Loss of power or limp mode
  • Low rail pressure code possible

Most Likely Root Causes

  • Harness chafed through, short to ground
  • Shorted turns in the regulator coil (resistance too low)
  • Water or corrosion in the connector
  • Output driver in the engine control module faulty

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside P0003.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Fuel Volume Regulator.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside P0003?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Fuel Volume Regulator.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Fuel Volume Regulator.
  5. 5Clear fault memory and run a verification cycle to confirm P0003 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$30 – $1,134
Professional Repair (Parts + Labor)$86 – $2,700

Frequently Asked Questions

Is it safe to keep operating with fault code P0003?

Avoid prolonged operation until inspected to prevent secondary component damage.

How much does it cost to repair P0003?

DIY replacement parts average $30–$1134, while professional service averages $86–$2700.

Will resetting P0003 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

P0003 fault code meaningP0003 repair costhow to fix P0003

Manufacturer & Technical Reference

OBD-II Technical Reference (Powertrain & Engine Management)

Related Fault Codes

Auto & OBD-II →
P0003 Fault Code: Fuel Volume Regulator A Control Circuit Low | FaultCodes.org