# OBD-II P0003: Fuel Volume Regulator A Control Circuit Low

> **Quick Answer:** OBD-II fault code P0003 indicates Fuel Volume Regulator A Control Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$2700.

- **URL:** https://faultcodes.org/automotive/obd2-p0003
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Powertrain & Engine Management
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The fuel volume regulator (also called metering unit or suction control valve) is a solenoid valve on the inlet side of the high-pressure pump, used mainly on common-rail diesel engines. The engine control module pulses it to set how much fuel the pump draws in and delivers to the rail, and in this way controls rail pressure. P0003 means the control module measures a voltage or current below the expected range on the control circuit, typically because of a short to ground. On some output stages an open circuit is also reported as low. A short on the switched ground side can keep the valve permanently energised.

## Common Symptoms
- Check engine light on
- Hard starting or stalling
- Loss of power or limp mode
- Low rail pressure code possible

## Most Likely Root Causes
- Harness chafed through, short to ground
- Shorted turns in the regulator coil (resistance too low)
- Water or corrosion in the connector
- Output driver in the engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fuel Volume Regulator.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fuel Volume Regulator.
5. Clear fault memory and run a verification cycle to confirm P0003 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$1134 | $86–$2700 |
| GBP | £24–£893 | £69–£2150 |
| CAD | CA$41–CA$1523 | CA$116–CA$3625 |
| EUR | €28–€1050 | €80–€2500 |
| CHF | CHF 32–CHF 1208 | CHF 106–CHF 3300 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0003?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0003?
DIY replacement parts average $30–$1134, while professional service averages $86–$2700.

### Will resetting P0003 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

