U0045 Fault Code: Vehicle Communication Bus B (-) Shorted to Bus B (+)
OBD-II U0045 (CAN Bus & Network Communication): Vehicle Communication Bus B (-) Shorted to Bus B (+).
OBD-II fault code U0045 indicates Vehicle Communication Bus B (-) Shorted to Bus B (+). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1080.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $86 – $1,080
What This Fault Code Means
U0045 describes the two wires of Vehicle Communication Bus B touching each other. Deutz uses this code in the EMR L1 engine controller for a short circuit on its third CAN channel, without further detail. On a high-speed-type CAN, bridged wires leave no differential voltage, every bit reads recessive and, per onsemi, nothing can be transmitted while the CANH driver works into its current limit; NXP adds that transceiver diagnosis cannot see this short. On a fault-tolerant low-speed network, NXP's TJA1055 first sees a permanent dominant level, then after a time-out switches off CAN-Low and keeps going on CAN-High. Typical causes are crushed harness sections, water in splices and a damaged module input. No car maker documents U0045 publicly; near-zero ohms between the wires with the battery off confirms the fault.
Common Symptoms
- Every function on Bus B unavailable (high-speed type)
- Several warning lamps on at once
- Lost-communication codes in modules on other networks
Most Likely Root Causes
- Harness crushed so that both bus wires touch
- Water in a splice or connector bridging the two wires
- Damaged module input shorting its bus pins
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0045.
- 2Inspect electrical connectors, fuses, and harnesses connected to Bus B Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0045?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0045 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $30 – $454 |
| Professional Repair (Parts + Labor) | $86 – $1,080 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0045 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $86 – $1,080
Frequently Asked Questions
Is it safe to keep operating with fault code U0045?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair U0045?
DIY replacement parts average $30–$454, while professional service averages $86–$1080.
Will resetting U0045 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)