# OBD-II U0045: Vehicle Communication Bus B (-) Shorted to Bus B (+)

> **Quick Answer:** OBD-II fault code U0045 indicates Vehicle Communication Bus B (-) Shorted to Bus B (+). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$1080.

- **URL:** https://faultcodes.org/automotive/obd2-u0045
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0045 describes the two wires of Vehicle Communication Bus B touching each other. Deutz uses this code in the EMR L1 engine controller for a short circuit on its third CAN channel, without further detail. On a high-speed-type CAN, bridged wires leave no differential voltage, every bit reads recessive and, per onsemi, nothing can be transmitted while the CANH driver works into its current limit; NXP adds that transceiver diagnosis cannot see this short. On a fault-tolerant low-speed network, NXP's TJA1055 first sees a permanent dominant level, then after a time-out switches off CAN-Low and keeps going on CAN-High. Typical causes are crushed harness sections, water in splices and a damaged module input. No car maker documents U0045 publicly; near-zero ohms between the wires with the battery off confirms the fault.

## Common Symptoms
- Every function on Bus B unavailable (high-speed type)
- Several warning lamps on at once
- Lost-communication codes in modules on other networks

## Most Likely Root Causes
- Harness crushed so that both bus wires touch
- Water in a splice or connector bridging the two wires
- Damaged module input shorting its bus pins

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
5. Clear fault memory and run a verification cycle to confirm U0045 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$454 | $86–$1080 |
| GBP | £24–£357 | £69–£860 |
| CAD | CA$41–CA$609 | CA$116–CA$1450 |
| EUR | €28–€420 | €80–€1000 |
| CHF | CHF 32–CHF 483 | CHF 106–CHF 1320 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0045?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0045?
DIY replacement parts average $30–$454, while professional service averages $86–$1080.

### Will resetting U0045 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

