U0044 Fault Code: Vehicle Communication Bus B (-) High
OBD-II U0044 (CAN Bus & Network Communication): Vehicle Communication Bus B (-) High.
OBD-II fault code U0044 indicates Vehicle Communication Bus B (-) High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$864.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $65 – $864
What This Fault Code Means
U0044 means the (-) conductor of Vehicle Communication Bus B is held at an excessive voltage, mostly through contact with battery plus. Where Bus B is a high-speed-type CAN, the conductor is CAN-Low, and onsemi found that with CAN-Low at 12 V no frame gets out any more; the node's current even drops, to about 48 mA, because its transmit pin is driven low only some 2 % of the time while the controller retries and backs off. All Bus B members fall silent together. A fault-tolerant low-speed CAN handles the same fault differently: NXP's TJA1055 detects it after a filter delay, turns off the CAN-Low driver and listens on CAN-High only. No manufacturer documents U0044 publicly. Ignition on, CAN-Low against ground near battery voltage confirms it; look for chafing at supply wires and water in connectors.
Common Symptoms
- All functions on Bus B fail together (high-speed type)
- Lost-communication codes in modules on other networks
- Fallback modes or warning lamps depending on the modules involved
Most Likely Root Causes
- (-) wire chafed against a battery or ignition feed
- Water in a connector linking the (-) wire to a supply pin
- Damaged transceiver driving the (-) line high
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0044.
- 2Inspect electrical connectors, fuses, and harnesses connected to Bus B Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0044?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0044 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $363 |
| Professional Repair (Parts + Labor) | $65 – $864 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0044 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $65 – $864
Frequently Asked Questions
Is it safe to keep operating with fault code U0044?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair U0044?
DIY replacement parts average $23–$363, while professional service averages $65–$864.
Will resetting U0044 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)