# OBD-II U0044: Vehicle Communication Bus B (-) High

> **Quick Answer:** OBD-II fault code U0044 indicates Vehicle Communication Bus B (-) High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0044
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0044 means the (-) conductor of Vehicle Communication Bus B is held at an excessive voltage, mostly through contact with battery plus. Where Bus B is a high-speed-type CAN, the conductor is CAN-Low, and onsemi found that with CAN-Low at 12 V no frame gets out any more; the node's current even drops, to about 48 mA, because its transmit pin is driven low only some 2 % of the time while the controller retries and backs off. All Bus B members fall silent together. A fault-tolerant low-speed CAN handles the same fault differently: NXP's TJA1055 detects it after a filter delay, turns off the CAN-Low driver and listens on CAN-High only. No manufacturer documents U0044 publicly. Ignition on, CAN-Low against ground near battery voltage confirms it; look for chafing at supply wires and water in connectors.

## Common Symptoms
- All functions on Bus B fail together (high-speed type)
- Lost-communication codes in modules on other networks
- Fallback modes or warning lamps depending on the modules involved

## Most Likely Root Causes
- (-) wire chafed against a battery or ignition feed
- Water in a connector linking the (-) wire to a supply pin
- Damaged transceiver driving the (-) line high

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
5. Clear fault memory and run a verification cycle to confirm U0044 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$363 | $65–$864 |
| GBP | £18–£286 | £52–£688 |
| CAD | CA$30–CA$487 | CA$87–CA$1160 |
| EUR | €21–€336 | €60–€800 |
| CHF | CHF 24–CHF 386 | CHF 79–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0044?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0044?
DIY replacement parts average $23–$363, while professional service averages $65–$864.

### Will resetting U0044 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

