U0043 Fault Code: Vehicle Communication Bus B (-) Low
OBD-II U0043 (CAN Bus & Network Communication): Vehicle Communication Bus B (-) Low.
OBD-II fault code U0043 indicates Vehicle Communication Bus B (-) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$756.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $65 – $756
What This Fault Code Means
U0043 reports the (-) line of Vehicle Communication Bus B shorted toward ground. Where Bus B is built like a high-speed CAN, that line is CAN-Low, and the fault is sneaky: onsemi measured frames still getting through, with distorted levels and the node drawing about 72 mA instead of 65 mA, because the CANH driver now pushes current through the termination into ground. NXP lists the case among hidden failures. NXP's fault-tolerant TJA1055 transceiver instead detects the short, switches off its CAN-Low driver and carries on single-wire over CAN-High. In both cases the vehicle tends to run normally, with the code logged by one module or showing up only now and then, which sets it apart from U0040, where the bus goes quiet. No manufacturer documents U0043 publicly; near-zero ohms from CAN-Low to ground confirms it.
Common Symptoms
- Vehicle mostly normal, code stored by a single module
- Occasional communication errors
Most Likely Root Causes
- (-) wire insulation damaged and touching ground
- Harness trapped under a panel or bracket
- Faulty transceiver pulling the (-) line to ground
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0043.
- 2Inspect electrical connectors, fuses, and harnesses connected to Bus B Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0043?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0043 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $318 |
| Professional Repair (Parts + Labor) | $65 – $756 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0043 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $65 – $756
Frequently Asked Questions
Is it safe to keep operating with fault code U0043?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair U0043?
DIY replacement parts average $23–$318, while professional service averages $65–$756.
Will resetting U0043 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)