# OBD-II U0043: Vehicle Communication Bus B (-) Low

> **Quick Answer:** OBD-II fault code U0043 indicates Vehicle Communication Bus B (-) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$756.

- **URL:** https://faultcodes.org/automotive/obd2-u0043
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0043 reports the (-) line of Vehicle Communication Bus B shorted toward ground. Where Bus B is built like a high-speed CAN, that line is CAN-Low, and the fault is sneaky: onsemi measured frames still getting through, with distorted levels and the node drawing about 72 mA instead of 65 mA, because the CANH driver now pushes current through the termination into ground. NXP lists the case among hidden failures. NXP's fault-tolerant TJA1055 transceiver instead detects the short, switches off its CAN-Low driver and carries on single-wire over CAN-High. In both cases the vehicle tends to run normally, with the code logged by one module or showing up only now and then, which sets it apart from U0040, where the bus goes quiet. No manufacturer documents U0043 publicly; near-zero ohms from CAN-Low to ground confirms it.

## Common Symptoms
- Vehicle mostly normal, code stored by a single module
- Occasional communication errors

## Most Likely Root Causes
- (-) wire insulation damaged and touching ground
- Harness trapped under a panel or bracket
- Faulty transceiver pulling the (-) line to ground

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Bus B Wiring.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Bus B Wiring.
5. Clear fault memory and run a verification cycle to confirm U0043 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$318 | $65–$756 |
| GBP | £18–£250 | £52–£602 |
| CAD | CA$30–CA$426 | CA$87–CA$1015 |
| EUR | €21–€294 | €60–€700 |
| CHF | CHF 24–CHF 338 | CHF 79–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0043?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0043?
DIY replacement parts average $23–$318, while professional service averages $65–$756.

### Will resetting U0043 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

