U0035 Fault Code: Vehicle Communication Bus A (-) High
OBD-II U0035 (CAN Bus & Network Communication): Vehicle Communication Bus A (-) High.
OBD-II fault code U0035 indicates Vehicle Communication Bus A (-) High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$864.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $65 – $864
What This Fault Code Means
U0035 means the (-) wire of Vehicle Communication Bus A is held too high, typically shorted to battery voltage. On a two-wire high-speed-type CAN, such as Audi's sensor/hybrid CAN filed under Bus A, this is CAN-Low. onsemi's tests place CAN-Low at 12 V among the shorts that make transmission impossible: frames can no longer be sent and the controllers repeat them without success. All modules on Bus A drop out together, and units on other networks register their absence. This is the opposite of U0034, where traffic survives. No manufacturer documents U0035 publicly. Measuring CAN-Low against ground with ignition on shows battery voltage instead of roughly 1.5 to 2.5 V; chafing against a supply wire or a water-filled connector are the usual reasons.
Common Symptoms
- All functions on Bus A fail together
- Lost-communication codes in modules on other networks
- Warning lamps or fallback modes depending on the modules involved
Most Likely Root Causes
- (-) wire chafed against a battery or ignition feed
- Water in a connector linking the (-) wire to a supply pin
- Damaged transceiver driving the (-) line high
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0035.
- 2Inspect electrical connectors, fuses, and harnesses connected to Bus A Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0035?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Bus A Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Bus A Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0035 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $363 |
| Professional Repair (Parts + Labor) | $65 – $864 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0035 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $65 – $864
Frequently Asked Questions
Is it safe to keep operating with fault code U0035?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair U0035?
DIY replacement parts average $23–$363, while professional service averages $65–$864.
Will resetting U0035 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)