U0033 Fault Code: Vehicle Communication Bus A (-) Open
OBD-II U0033 (CAN Bus & Network Communication): Vehicle Communication Bus A (-) Open.
OBD-II fault code U0033 indicates Vehicle Communication Bus A (-) Open. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$756.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $65 – $756
What This Fault Code Means
U0033 reports an interruption of the (-) wire of Vehicle Communication Bus A; on a dual-line CAN like the sensor/hybrid CAN Audi lists as Bus A, that is CAN-Low. As with U0030, the network falls apart into pieces that can no longer hear each other, and NXP stresses that a standard high-speed transceiver has no means of detecting an open wire on its own. The control module infers the fault indirectly, for example from expected messages that stop arriving or from rising error counters, so the code often appears next to lost-communication entries for modules beyond the break. No manufacturer documents U0033 publicly. With the battery disconnected, a resistance between (+) and (-) that differs from the normal termination value hints at the break; check recently separated connectors first.
Common Symptoms
- Modules beyond the break stop responding
- Lost-communication codes stored alongside
Most Likely Root Causes
- (-) wire of Bus A broken in the harness
- Pushed-back or corroded terminal in a connector
- Connector not reconnected after a repair
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0033.
- 2Inspect electrical connectors, fuses, and harnesses connected to Bus A Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0033?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Bus A Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Bus A Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0033 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $23 – $318 |
| Professional Repair (Parts + Labor) | $65 – $756 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0033 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $65 – $756
Frequently Asked Questions
Is it safe to keep operating with fault code U0033?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair U0033?
DIY replacement parts average $23–$318, while professional service averages $65–$756.
Will resetting U0033 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)