U0020 Fault Code: Low Speed CAN Communication Bus Performance
OBD-II U0020 (CAN Bus & Network Communication): Low Speed CAN Communication Bus Performance.
OBD-II fault code U0020 indicates Low Speed CAN Communication Bus Performance. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$432.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- CAN Bus & Network Communication
- Professional Repair
- $43 – $432
What This Fault Code Means
U0020 reports a low-speed CAN that still runs but delivers its traffic unreliably. GM documents it for the 2011 Saab 9-5, whose low-speed GMLAN is a single wire: a module sets U0020 when a monitored cyclic message, which doubles as proof that the sender is available, fails to arrive, and then substitutes a default value. Saab adds that some modules store it when the bus wakes up or the supply returns before they have learned which partners are present; diagnosis follows the symptoms or the U0100-U02FF codes. GM told technicians to ignore a current U0020 in the video processing module of 2019 Silverado/Sierra trucks as a software artefact, and lists it for 2017 trucks whose gateway module hangs until its fuse is pulled. Unlike U0019 the bus itself is usually intact.
Common Symptoms
- Often no noticeable symptom, code found during a scan
- Sporadic dropouts of comfort or display functions
- Several modules store communication codes at the same time
Most Likely Root Causes
- Code stored while modules wake up or after the supply was interrupted
- Software anomaly in one module (GM video processing module 2019)
- Gateway module stops communicating or has loose terminals
- Intermittent contact in the low-speed bus wiring
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0020.
- 2Inspect electrical connectors, fuses, and harnesses connected to Low Speed Can Wiring.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0020?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Low Speed Can Wiring.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Low Speed Can Wiring.
- 5Clear fault memory and run a verification cycle to confirm U0020 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $16 – $181 |
| Professional Repair (Parts + Labor) | $43 – $432 |
Frequently Asked Questions
Is it safe to keep operating with fault code U0020?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair U0020?
DIY replacement parts average $16–$181, while professional service averages $43–$432.
Will resetting U0020 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)