FaultCodes.org
U0018OBD-IICAN Bus & Network CommunicationTechnical Reference· Updated: Nov 22, 2026

U0018 Fault Code: Medium Speed CAN Communication Bus (-) Shorted to Bus (+)

OBD-II U0018 (CAN Bus & Network Communication): Medium Speed CAN Communication Bus (-) Shorted to Bus (+).

Quick AnswerModerate — Plan Repair

OBD-II fault code U0018 indicates Medium Speed CAN Communication Bus (-) Shorted to Bus (+). Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$864.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
CAN Bus & Network Communication
Professional Repair
$54 – $864

What This Fault Code Means

U0018 describes the two medium-speed CAN lines, CAN-Low and CAN-High, shorted together. With no voltage difference left, receivers see only recessive bits, nobody can win arbitration, and the controllers on the segment eventually go bus-off; onsemi's measurements on the comparable high-speed layer show transmission stopping completely. NXP notes that transceiver diagnosis does not catch this short, so it is inferred from protocol errors. No manufacturer documents U0018 publicly. Expect the complete comfort network to fail together while the powertrain bus stays unaffected. With the battery disconnected, a near-zero resistance between (+) and (-) in place of the normal termination value confirms it; separating connectors section by section narrows the location, often a crushed or wet harness.

Common Symptoms

  • Entire comfort network fails, powertrain unaffected
  • Body modules unreachable with the scan tool

Most Likely Root Causes

  • Medium-speed bus pair crushed so both wires touch
  • Water in a connector bridging (+) and (-)
  • Failed transceiver shorting both bus pins in a comfort module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside U0018.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Can High Wire.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside U0018?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Can High Wire.
  5. 5Clear fault memory and run a verification cycle to confirm U0018 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $363
Professional Repair (Parts + Labor)$54 – $864

Frequently Asked Questions

Is it safe to keep operating with fault code U0018?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair U0018?

DIY replacement parts average $19–$363, while professional service averages $54–$864.

Will resetting U0018 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

U0018 fault code meaningU0018 repair costhow to fix U0018

Manufacturer & Technical Reference

OBD-II Technical Reference (CAN Bus & Network Communication)

Related Fault Codes

Auto & OBD-II →
U0018 Fault Code: Medium Speed CAN Communication… — Fixes & Cost | FaultCodes.org