# OBD-II U0018: Medium Speed CAN Communication Bus (-) Shorted to Bus (+)

> **Quick Answer:** OBD-II fault code U0018 indicates Medium Speed CAN Communication Bus (-) Shorted to Bus (+). Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0018
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0018 describes the two medium-speed CAN lines, CAN-Low and CAN-High, shorted together. With no voltage difference left, receivers see only recessive bits, nobody can win arbitration, and the controllers on the segment eventually go bus-off; onsemi's measurements on the comparable high-speed layer show transmission stopping completely. NXP notes that transceiver diagnosis does not catch this short, so it is inferred from protocol errors. No manufacturer documents U0018 publicly. Expect the complete comfort network to fail together while the powertrain bus stays unaffected. With the battery disconnected, a near-zero resistance between (+) and (-) in place of the normal termination value confirms it; separating connectors section by section narrows the location, often a crushed or wet harness.

## Common Symptoms
- Entire comfort network fails, powertrain unaffected
- Body modules unreachable with the scan tool

## Most Likely Root Causes
- Medium-speed bus pair crushed so both wires touch
- Water in a connector bridging (+) and (-)
- Failed transceiver shorting both bus pins in a comfort module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can High Wire.
5. Clear fault memory and run a verification cycle to confirm U0018 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$363 | $54–$864 |
| GBP | £15–£286 | £43–£688 |
| CAD | CA$26–CA$487 | CA$73–CA$1160 |
| EUR | €18–€336 | €50–€800 |
| CHF | CHF 21–CHF 386 | CHF 66–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0018?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0018?
DIY replacement parts average $19–$363, while professional service averages $54–$864.

### Will resetting U0018 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

