U0016 Fault Code: Medium Speed CAN Communication Bus (-) Low
OBD-II U0016 (CAN Bus & Network Communication): Medium Speed CAN Communication Bus (-) Low.
OBD-II fault code U0016 indicates Medium Speed CAN Communication Bus (-) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$648.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Moderate (Intermediate)
- System
- CAN Bus & Network Communication
- Professional Repair
- $54 – $648
What This Fault Code Means
U0016 reports CAN-Low of the medium-speed bus, the (-) wire, sitting below its valid range, typically through a short to ground. Transferred from the high-speed physical layer, which Saab's two-wire terminated mid-speed GMLAN resembles, this is a fault the bus tolerates: onsemi measured continuing transmission with deformed levels, and NXP files it as a hidden failure visible only to transceivers with diagnosis. The comfort network therefore usually keeps working, but becomes more sensitive to interference; drivers rarely notice anything beyond sporadic glitches. No manufacturer documents U0016 publicly. Because the fault hides so well, the code itself is often the only clue; measure CAN-Low against ground with the battery disconnected and follow the harness near sharp edges.
Common Symptoms
- Usually no lasting malfunction, code found during a scan
- Sporadic glitches in comfort functions
Most Likely Root Causes
- Medium-speed CAN-Low chafed against a ground point or sheet edge
- Water ingress in a footwell or door connector
- Comfort module transceiver internally shorted on CAN-Low
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0016.
- 2Inspect electrical connectors, fuses, and harnesses connected to Can Low Wire.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0016?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Can Low Wire.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Can Low Wire.
- 5Clear fault memory and run a verification cycle to confirm U0016 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $19 – $272 |
| Professional Repair (Parts + Labor) | $54 – $648 |
Frequently Asked Questions
Is it safe to keep operating with fault code U0016?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair U0016?
DIY replacement parts average $19–$272, while professional service averages $54–$648.
Will resetting U0016 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)