FaultCodes.org
U0014OBD-IICAN Bus & Network CommunicationTechnical Reference· Updated: Nov 22, 2026

U0014 Fault Code: Medium Speed CAN Communication Bus (+) High

OBD-II U0014 (CAN Bus & Network Communication): Medium Speed CAN Communication Bus (+) High.

Quick AnswerModerate — Plan Repair

OBD-II fault code U0014 indicates Medium Speed CAN Communication Bus (+) High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$648.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
CAN Bus & Network Communication
Professional Repair
$54 – $648

What This Fault Code Means

U0014 means CAN-High of the medium-speed bus lies above its normal range, most often because the (+) wire touches battery voltage. On a differential CAN of the high-speed type this is a fault the network rides through: onsemi and NXP found frames still being delivered, but with shifted levels, reduced noise margin and higher current draw in the transceivers. NXP calls such a short hidden because only transceivers with built-in diagnosis notice it. On the comfort bus the result tends to be subtle: an occasional unresponsive switch, a flickering display or a stored code without complaint. No manufacturer documents U0014 publicly, and Saab's description shows only the two-wire terminated layout that makes this analogy plausible. A CAN-High reading close to battery voltage with ignition on confirms the short.

Common Symptoms

  • Occasional unresponsive switches or flickering displays
  • Stored code without obvious malfunction

Most Likely Root Causes

  • Medium-speed CAN-High rubbing against a supply wire
  • Moisture in a door or roof connector linking CAN-High to plus
  • Aftermarket device wired to the comfort bus incorrectly

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside U0014.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Can High Wire.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside U0014?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Can High Wire.
  5. 5Clear fault memory and run a verification cycle to confirm U0014 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $272
Professional Repair (Parts + Labor)$54 – $648

Frequently Asked Questions

Is it safe to keep operating with fault code U0014?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair U0014?

DIY replacement parts average $19–$272, while professional service averages $54–$648.

Will resetting U0014 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

U0014 fault code meaningU0014 repair costhow to fix U0014

Manufacturer & Technical Reference

OBD-II Technical Reference (CAN Bus & Network Communication)

Related Fault Codes

Auto & OBD-II →
U0014 Fault Code: Medium Speed CAN Communication Bus (+) High | FaultCodes.org