FaultCodes.org
U0013OBD-IICAN Bus & Network CommunicationTechnical Reference· Updated: Nov 22, 2026

U0013 Fault Code: Medium Speed CAN Communication Bus (+) Low

OBD-II U0013 (CAN Bus & Network Communication): Medium Speed CAN Communication Bus (+) Low.

Quick AnswerModerate — Plan Repair

OBD-II fault code U0013 indicates Medium Speed CAN Communication Bus (+) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$756.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Moderate (Intermediate)
System
CAN Bus & Network Communication
Professional Repair
$54 – $756

What This Fault Code Means

U0013 indicates that CAN-High on the medium-speed bus, the (+) wire, is pulled toward ground. Where this network uses the same differential layout as high-speed CAN, as Saab's terminated mid-speed GMLAN suggests, a grounded CAN-High rules out any dominant bit; onsemi and NXP list this short among those that end all communication. Every node on the segment, usually body, climate and infotainment units, therefore goes quiet together, and the gateway or body controller stores missing-message codes for them. No manufacturer documents U0013 publicly. Powertrain functions on the separate fast bus normally carry on. With the battery off, a resistance of only a few ohms from CAN-High to ground locates the short; typical spots are door boots, seat rails and trim fasteners.

Common Symptoms

  • All comfort and infotainment modules fail together
  • Engine and transmission keep working normally

Most Likely Root Causes

  • Medium-speed CAN-High insulation damaged against body ground
  • Wires broken open in a door boot or tailgate grommet
  • Comfort module transceiver pulling CAN-High down

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside U0013.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Can High Wire.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside U0013?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Can High Wire.
  5. 5Clear fault memory and run a verification cycle to confirm U0013 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$19 – $318
Professional Repair (Parts + Labor)$54 – $756

Frequently Asked Questions

Is it safe to keep operating with fault code U0013?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair U0013?

DIY replacement parts average $19–$318, while professional service averages $54–$756.

Will resetting U0013 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

U0013 fault code meaningU0013 repair costhow to fix U0013

Manufacturer & Technical Reference

OBD-II Technical Reference (CAN Bus & Network Communication)

Related Fault Codes

Auto & OBD-II →
U0013 Fault Code: Medium Speed CAN Communication Bus (+) Low | FaultCodes.org