# OBD-II U0013: Medium Speed CAN Communication Bus (+) Low

> **Quick Answer:** OBD-II fault code U0013 indicates Medium Speed CAN Communication Bus (+) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$756.

- **URL:** https://faultcodes.org/automotive/obd2-u0013
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0013 indicates that CAN-High on the medium-speed bus, the (+) wire, is pulled toward ground. Where this network uses the same differential layout as high-speed CAN, as Saab's terminated mid-speed GMLAN suggests, a grounded CAN-High rules out any dominant bit; onsemi and NXP list this short among those that end all communication. Every node on the segment, usually body, climate and infotainment units, therefore goes quiet together, and the gateway or body controller stores missing-message codes for them. No manufacturer documents U0013 publicly. Powertrain functions on the separate fast bus normally carry on. With the battery off, a resistance of only a few ohms from CAN-High to ground locates the short; typical spots are door boots, seat rails and trim fasteners.

## Common Symptoms
- All comfort and infotainment modules fail together
- Engine and transmission keep working normally

## Most Likely Root Causes
- Medium-speed CAN-High insulation damaged against body ground
- Wires broken open in a door boot or tailgate grommet
- Comfort module transceiver pulling CAN-High down

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can High Wire.
5. Clear fault memory and run a verification cycle to confirm U0013 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$318 | $54–$756 |
| GBP | £15–£250 | £43–£602 |
| CAD | CA$26–CA$426 | CA$73–CA$1015 |
| EUR | €18–€294 | €50–€700 |
| CHF | CHF 21–CHF 338 | CHF 66–CHF 924 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0013?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0013?
DIY replacement parts average $19–$318, while professional service averages $54–$756.

### Will resetting U0013 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

