U0007 Fault Code: High Speed CAN Communication Bus (-) Low
OBD-II U0007 (CAN Bus & Network Communication): High Speed CAN Communication Bus (-) Low.
OBD-II fault code U0007 indicates High Speed CAN Communication Bus (-) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$864.
- Safe to Operate?
- Yes (Short Term)
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $86 – $864
What This Fault Code Means
U0007 reports that the (-) line CAN-Low on the fast bus is held below its valid band, normally by a short to ground. The physical layer copes with this particular case: onsemi recorded ongoing transmission with a distorted level pattern and raised transceiver current, and NXP counts it among the hidden failures. Traffic therefore continues, yet the reserve against interference shrinks, which may surface as an occasional lost frame or a brief warning. Only modules whose transceiver offers bus diagnosis can spot the condition directly. No manufacturer documents U0007 publicly; FCA field cases describe ground shorts on the CAN C (+) and (-) lines under U0001. Inspect sections near sheet-metal edges, brackets and seat rails, then measure CAN-Low to ground with the battery disconnected.
Common Symptoms
- Usually no noticeable malfunction, code found during a scan
- Occasional short-lived warnings, worse with moisture
Most Likely Root Causes
- CAN-Low insulation worn through against body metal
- Water in a connector bridging CAN-Low to a ground pin
- Module transceiver internally shorted on its CAN-Low pin
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0007.
- 2Inspect electrical connectors, fuses, and harnesses connected to Can Low Wire.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0007?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Can Low Wire.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Can Low Wire.
- 5Clear fault memory and run a verification cycle to confirm U0007 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $30 – $363 |
| Professional Repair (Parts + Labor) | $86 – $864 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0007 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $86 – $864
Frequently Asked Questions
Is it safe to keep operating with fault code U0007?
Usually safe for short trips if no severe drivability or safety warnings are active.
How much does it cost to repair U0007?
DIY replacement parts average $30–$363, while professional service averages $86–$864.
Will resetting U0007 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)