# OBD-II U0007: High Speed CAN Communication Bus (-) Low

> **Quick Answer:** OBD-II fault code U0007 indicates High Speed CAN Communication Bus (-) Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0007
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0007 reports that the (-) line CAN-Low on the fast bus is held below its valid band, normally by a short to ground. The physical layer copes with this particular case: onsemi recorded ongoing transmission with a distorted level pattern and raised transceiver current, and NXP counts it among the hidden failures. Traffic therefore continues, yet the reserve against interference shrinks, which may surface as an occasional lost frame or a brief warning. Only modules whose transceiver offers bus diagnosis can spot the condition directly. No manufacturer documents U0007 publicly; FCA field cases describe ground shorts on the CAN C (+) and (-) lines under U0001. Inspect sections near sheet-metal edges, brackets and seat rails, then measure CAN-Low to ground with the battery disconnected.

## Common Symptoms
- Usually no noticeable malfunction, code found during a scan
- Occasional short-lived warnings, worse with moisture

## Most Likely Root Causes
- CAN-Low insulation worn through against body metal
- Water in a connector bridging CAN-Low to a ground pin
- Module transceiver internally shorted on its CAN-Low pin

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can Low Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can Low Wire.
5. Clear fault memory and run a verification cycle to confirm U0007 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$363 | $86–$864 |
| GBP | £24–£286 | £69–£688 |
| CAD | CA$41–CA$487 | CA$116–CA$1160 |
| EUR | €28–€336 | €80–€800 |
| CHF | CHF 32–CHF 386 | CHF 106–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0007?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0007?
DIY replacement parts average $30–$363, while professional service averages $86–$864.

### Will resetting U0007 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

