FaultCodes.org
U0005OBD-IICAN Bus & Network CommunicationTechnical Reference· Updated: Nov 22, 2026

U0005 Fault Code: High Speed CAN Communication Bus (+) High

OBD-II U0005 (CAN Bus & Network Communication): High Speed CAN Communication Bus (+) High.

Quick AnswerModerate — Plan Repair

OBD-II fault code U0005 indicates High Speed CAN Communication Bus (+) High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$864.

Safe to Operate?
Yes (Short Term)
DIY Difficulty
Professional Recommended
System
CAN Bus & Network Communication
Professional Repair
$86 – $864

What This Fault Code Means

U0005 flags CAN-High, the (+) wire of the high-speed bus, sitting above its permitted range, generally because it touches battery voltage or a 5 V feed. Unlike a ground short this does not have to halt traffic: onsemi and NXP both found that frames still pass, but the voltage picture is distorted, noise immunity worsens and, on networks with a large capacitive load, bit timing can be violated. NXP therefore classes it as a hidden bus failure that only transceivers with diagnosis can see. The usual result is occasional message loss, intermittent warnings, or a single module that reports the fault while the car drives normally. No manufacturer documents U0005 publicly. Measuring CAN-High against ground with ignition on shows a value near supply voltage instead of about 2.5 to 3.5 V.

Common Symptoms

  • Sporadic warnings, often with no lasting malfunction
  • Individual messages or modules dropping out under load or in damp weather

Most Likely Root Causes

  • CAN-High chafed through against a battery or ignition feed
  • Moisture bridging CAN-High to a supply pin in a connector
  • Incorrectly connected accessory or retrofit module

Diagnostic Checks Before Replacing Parts

Verify the exact faulty component before ordering replacements.

  1. 1Read stored freeze-frame data and companion codes alongside U0005.
  2. 2Inspect electrical connectors, fuses, and harnesses connected to Can High Wire.
  3. 3Verify live sensor telemetry before ordering replacement components.

Interactive Symptom Triage

Answer 3 quick checks to narrow down the faulty component before spending money on parts.

Check 1 of 3

Are any companion fault codes stored alongside U0005?

Step-by-Step Troubleshooting & Fix

  1. 1Scan for companion fault codes and address upstream circuit issues first.
  2. 2Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
  3. 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
  4. 4Repair damaged wiring or install an OEM-grade replacement Can High Wire.
  5. 5Clear fault memory and run a verification cycle to confirm U0005 does not return.

Estimated Repair Cost Benchmark

Typical DIY parts and certified technician labor ranges. Select a currency below.

Currency:
Repair PathUSD
DIY Parts Only$30 – $363
Professional Repair (Parts + Labor)$86 – $864

Certified Technician Service Checklist

This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.

  • Share exact brand & fault code: U0005 (CAN Bus & Network Communication)
  • Record appliance/boiler serial, model plate, or pressure reading before calling
  • Typical certified technician range: $86 – $864

Frequently Asked Questions

Is it safe to keep operating with fault code U0005?

Usually safe for short trips if no severe drivability or safety warnings are active.

How much does it cost to repair U0005?

DIY replacement parts average $30–$363, while professional service averages $86–$864.

Will resetting U0005 fix the problem permanently?

No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

Related Searches & Questions

U0005 fault code meaningU0005 repair costhow to fix U0005

Manufacturer & Technical Reference

OBD-II Technical Reference (CAN Bus & Network Communication)

Related Fault Codes

Auto & OBD-II →
U0005 Fault Code: High Speed CAN Communication Bus (+) High | FaultCodes.org