# OBD-II U0005: High Speed CAN Communication Bus (+) High

> **Quick Answer:** OBD-II fault code U0005 indicates High Speed CAN Communication Bus (+) High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $86–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0005
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0005 flags CAN-High, the (+) wire of the high-speed bus, sitting above its permitted range, generally because it touches battery voltage or a 5 V feed. Unlike a ground short this does not have to halt traffic: onsemi and NXP both found that frames still pass, but the voltage picture is distorted, noise immunity worsens and, on networks with a large capacitive load, bit timing can be violated. NXP therefore classes it as a hidden bus failure that only transceivers with diagnosis can see. The usual result is occasional message loss, intermittent warnings, or a single module that reports the fault while the car drives normally. No manufacturer documents U0005 publicly. Measuring CAN-High against ground with ignition on shows a value near supply voltage instead of about 2.5 to 3.5 V.

## Common Symptoms
- Sporadic warnings, often with no lasting malfunction
- Individual messages or modules dropping out under load or in damp weather

## Most Likely Root Causes
- CAN-High chafed through against a battery or ignition feed
- Moisture bridging CAN-High to a supply pin in a connector
- Incorrectly connected accessory or retrofit module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can High Wire.
5. Clear fault memory and run a verification cycle to confirm U0005 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$363 | $86–$864 |
| GBP | £24–£286 | £69–£688 |
| CAD | CA$41–CA$487 | CA$116–CA$1160 |
| EUR | €28–€336 | €80–€800 |
| CHF | CHF 32–CHF 386 | CHF 106–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0005?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair U0005?
DIY replacement parts average $30–$363, while professional service averages $86–$864.

### Will resetting U0005 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

