U0003 Fault Code: High Speed CAN Communication Bus (+) Open
OBD-II U0003 (CAN Bus & Network Communication): High Speed CAN Communication Bus (+) Open.
OBD-II fault code U0003 indicates High Speed CAN Communication Bus (+) Open. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$864.
- Safe to Operate?
- No — Risk of Damage
- DIY Difficulty
- Professional Recommended
- System
- CAN Bus & Network Communication
- Professional Repair
- $86 – $864
What This Fault Code Means
U0003 reports a break in the (+) wire of the high-speed CAN, which GM and FCA also call CAN-High. At rest this line idles near 2.5 V and is lifted about one volt for each dominant bit. Once it is cut, modules on the far side of the break lose the differential pair and drop out, while nodes on the intact section may keep talking. Standard high-speed transceivers cannot report a wire interruption on their own, as NXP points out, so whether a module stores U0003 depends on its own monitoring. Harley-Davidson lists U0003 together with U0001 as history codes in the ABS unit of 2017 Touring models when the TechLink interface was plugged in with the ignition already on; there no repair is due. Genuine breaks come from chafing, pushed-back terminals or corrosion.
Common Symptoms
- Modules beyond the break no longer reachable
- Several warnings and fallback modes at once
- Fault appears or disappears when the harness is moved
Most Likely Root Causes
- CAN-High conductor broken at a flex point or after a repair
- CAN-High terminal pushed back or corroded in a connector
- Diagnostic interface connected with ignition on (history code only)
Diagnostic Checks Before Replacing Parts
Verify the exact faulty component before ordering replacements.
- 1Read stored freeze-frame data and companion codes alongside U0003.
- 2Inspect electrical connectors, fuses, and harnesses connected to Can High Wire.
- 3Verify live sensor telemetry before ordering replacement components.
Interactive Symptom Triage
Answer 3 quick checks to narrow down the faulty component before spending money on parts.
Are any companion fault codes stored alongside U0003?
Step-by-Step Troubleshooting & Fix
- 1Scan for companion fault codes and address upstream circuit issues first.
- 2Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
- 3Test component voltage, resistance, or mechanical actuation with diagnostic tools.
- 4Repair damaged wiring or install an OEM-grade replacement Can High Wire.
- 5Clear fault memory and run a verification cycle to confirm U0003 does not return.
Estimated Repair Cost Benchmark
Typical DIY parts and certified technician labor ranges. Select a currency below.
| Repair Path | USD |
|---|---|
| DIY Parts Only | $30 – $363 |
| Professional Repair (Parts + Labor) | $86 – $864 |
Certified Technician Service Checklist
This fault involves sealed safety, gas, or high-voltage systems. Share these details when requesting a repair quote.
- Share exact brand & fault code: U0003 (CAN Bus & Network Communication)
- Record appliance/boiler serial, model plate, or pressure reading before calling
- Typical certified technician range: $86 – $864
Frequently Asked Questions
Is it safe to keep operating with fault code U0003?
Avoid prolonged operation until inspected to prevent secondary component damage.
How much does it cost to repair U0003?
DIY replacement parts average $30–$363, while professional service averages $86–$864.
Will resetting U0003 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.
Related Searches & Questions
Manufacturer & Technical Reference
OBD-II Technical Reference (CAN Bus & Network Communication)