# OBD-II U0003: High Speed CAN Communication Bus (+) Open

> **Quick Answer:** OBD-II fault code U0003 indicates High Speed CAN Communication Bus (+) Open. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$864.

- **URL:** https://faultcodes.org/automotive/obd2-u0003
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** CAN Bus & Network Communication
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
U0003 reports a break in the (+) wire of the high-speed CAN, which GM and FCA also call CAN-High. At rest this line idles near 2.5 V and is lifted about one volt for each dominant bit. Once it is cut, modules on the far side of the break lose the differential pair and drop out, while nodes on the intact section may keep talking. Standard high-speed transceivers cannot report a wire interruption on their own, as NXP points out, so whether a module stores U0003 depends on its own monitoring. Harley-Davidson lists U0003 together with U0001 as history codes in the ABS unit of 2017 Touring models when the TechLink interface was plugged in with the ignition already on; there no repair is due. Genuine breaks come from chafing, pushed-back terminals or corrosion.

## Common Symptoms
- Modules beyond the break no longer reachable
- Several warnings and fallback modes at once
- Fault appears or disappears when the harness is moved

## Most Likely Root Causes
- CAN-High conductor broken at a flex point or after a repair
- CAN-High terminal pushed back or corroded in a connector
- Diagnostic interface connected with ignition on (history code only)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Can High Wire.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Can High Wire.
5. Clear fault memory and run a verification cycle to confirm U0003 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$363 | $86–$864 |
| GBP | £24–£286 | £69–£688 |
| CAD | CA$41–CA$487 | CA$116–CA$1160 |
| EUR | €28–€336 | €80–€800 |
| CHF | CHF 32–CHF 386 | CHF 106–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code U0003?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair U0003?
DIY replacement parts average $30–$363, while professional service averages $86–$864.

### Will resetting U0003 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

